Great instructions! Love my 951 XC I did swap out the tires to 2.3 Aggressor rear and a 2.5 Minion DHF front....so happy and pleased with my purchase....I’ve never freakin even had to adjust my derailleur!!!! Great job guys 👍🤙❤️
I noticed when you tapped the tire on the ground to distribute the sealant you did it with the rotor facing up for the front tire, and the rotor facing down (cassette up) for the rear. Is that orientation difference important? Are we supposed to tap the wheel on both sides (rotor facing up, and then rotor facing down), or just the one side shown in the video? Thanks 👍
Sometimes you have to go well over 30 PSI to get the bead to pop. The tire should have a max PSI on the sidewall so you know where to stop. If it still doesn't pop, you can kinda bounce the wheel around to jiggle the rubber and then just go have dinner and remember not to be scared by the pop in the other room 20 minutes later (who would do that??).
Thanks for including this…loving my new bike and this conversion was crazy simple!
Great instructions!
Love my 951 XC
I did swap out the tires to 2.3 Aggressor rear and a 2.5 Minion DHF front....so happy and pleased with my purchase....I’ve never freakin even had to adjust my derailleur!!!!
Great job guys 👍🤙❤️
You guys have the tubeless tape already installed? And you include stems and sealant too? You guys are the best!
All of these instructional videos are great!
We appreciate the feedback. There will be plenty more to come!
Is a tire lever supposed to be included with the bike?
I noticed when you tapped the tire on the ground to distribute the sealant you did it with the rotor facing up for the front tire, and the rotor facing down (cassette up) for the rear. Is that orientation difference important? Are we supposed to tap the wheel on both sides (rotor facing up, and then rotor facing down), or just the one side shown in the video? Thanks 👍
Hi Mike! The orientation to tap your tire to distribute the sealant does not matter. Either way is okay! Cheers
Is the process the same for 1x gravel?
Tire wont bead properly. Big leak after two pops 😭
Sometimes you have to go well over 30 PSI to get the bead to pop. The tire should have a max PSI on the sidewall so you know where to stop. If it still doesn't pop, you can kinda bounce the wheel around to jiggle the rubber and then just go have dinner and remember not to be scared by the pop in the other room 20 minutes later (who would do that??).
So complicated