Should you Liberty Walk your e92 bmw? THINK TWICE!
Вставка
- Опубліковано 5 вер 2024
- Hey guys, today I just wanted to do a montage of the liberty walk wide body kit. This is being held by tape, so obviously it is not straight or perfectly aligned. Various mods are required for the install. You need to cut front and rear fenders,bumper, and wideer tires (Spacers work too). I did not put my M3 style bumper/Fenders yet, but here is a rough look at the wide body kit. Thanks again.
Music by NOES
Check them out!!
Do you know what size rear wheel you were going to need?? Is this the duraflex kit?
dreezy franklin yes! Also known as the circuit kit. Well I tried it with 19x11 offset +25 with 325 30 19 and I still needed a 1-1.5 spacer. Maybe a 0 offset rim would have fixed the issue. Good luck!!
I'm Not A Car Guy it's almost impossible to find 19x12 for good price. This circuit kit is a littl3 l3ss dramatic than the liberty body kit it seems? The circuit version a little less wider or is it about the same ?
I'm Not A Car Guy and where those dimensions yoh tried for the front or rear ?
dreezy franklin no, only for the rear. In the front I have 255 30 19 on 19x9.5 + 35 . They weren't wide enough. Unfortunately I didn't get a chance to take any videos of the setup.
did u do it ? just swap m3 kit first then install it, me own e92 320i swap 2jz 450hp n m3 taiwan full kit, later will install lb kit i dont think twice bcause this is my goals!
M3 kit right..what about rear fenders you have to get the rear quarters and fit them on 3 series to have rear arches wide same as M3
@@nikolasael1 no i dont wide my rear fender at all actually i want to do so but since its hard to find a bigger offset wheel in my place i prefer not to.
Do you think this kit could work with a 328i
LIL SLUMP it should. Just the front bumper would look a little off since there’s no air duct. Try to buy a polyurethane kit. This one was fiberglass and did not flex. It just looks better without any gaps... good luck!!
I'm Not A Car Guy What do you think about buying just the M3 fender flares for the back since the 328i ones aren’t that good and then buying the 328i ones for the front
Are the m3 fenders necessary?
AK540i honestly, the one I had was fiber glass.. so it’s less easy to work with than polyurethane... but I’m sure you can cut it and bondo to blend in the rough edges. There are kits that are made for the 335i. Let me see if I find the link