Make sure you keep that back door locked if you have a waste gate open it sticks out past the door when open lol. I didnt think it was that loud at all.
When you removed the fan, were you able to continue to use the same exit fitting minus the fan to attach the hose? Was it difficult to remove the fan? My Lasermatic should arrive soon and I'm trying to sort out an exhaust for it, which is going to be very similar to yours. Thanks.
I just used shorter bolts and put the duct back on. Once you unplug fan,wire with connector will slide out of the aluminum channel,no reason to try and pry it off.Its very easy to do.I also left the fan screen on the inside.
I just purchased this fan its great! 👍 im still trying to figure out how to remove the factory fan without cutting the wires or damage the condit or orange plastic? The fans cord won't fit through the Condit Roly used.
Unclip the fan,the wire is like 6 inches long.Do not remove the silver metal duct.The wire and connector will slide through it.Then use shorter bolts for duct with grate. Save fan and screws,if you ever sell it,you can put back to stock.
Looking good Jerry, good airquality is important in your makerspace when you spend a lot of time there.
Looking good Jerry as always I love that unboxing knife
Really like the ac infinity. I use the 6in hose up until the last 5 in and have a reducer for 6 to 4.
Great start! Always good to have a laugh!
I might upgrade the Hon&Guan 130 CFM it's Junk for my Roly 20w , I just etched a bunch of mirrors today. my basement smells like a plastic factory.
Well that's no good.You don't want to be breathing in anything that might have harmful chemicals in it.
Make sure you keep that back door locked if you have a waste gate open it sticks out past the door when open lol. I didnt think it was that loud at all.
It easily turns at the Y. Thought about when I screwed to the wall.Louder than the smaller one,but ok.
I had one of these, and it seemed the only settings that worked were the last two. Should just be High/Low.
Great System set up! 🫡
When you removed the fan, were you able to continue to use the same exit fitting minus the fan to attach the hose? Was it difficult to remove the fan? My Lasermatic should arrive soon and I'm trying to sort out an exhaust for it, which is going to be very similar to yours. Thanks.
I just used shorter bolts and put the duct back on. Once you unplug fan,wire with connector will slide out of the aluminum channel,no reason to try and pry it off.Its very easy to do.I also left the fan screen on the inside.
@@3DHP Thanks! Great explanation!
Do you use a window to vent
lol,,you didn't watch the video.
I just purchased this fan its great! 👍 im still trying to figure out how to remove the factory fan without cutting the wires or damage the condit or orange plastic? The fans cord won't fit through the Condit Roly used.
Unclip the fan,the wire is like 6 inches long.Do not remove the silver metal duct.The wire and connector will slide through it.Then use shorter bolts for duct with grate. Save fan and screws,if you ever sell it,you can put back to stock.
@@3DHP ok thanks 👍👍👍👍👍