Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
Where is the video on fixing a bend in the front flange that you mentioned at the end of this video. I don't see it on your channel.
@@kencecil697 for the cutting edge it’s the same process I used for the top edge. I think I did another video on the sides. Let me check for it.
@@kencecil697 ua-cam.com/video/PO-ImfYhiPI/v-deo.htmlsi=bEvRjEJ3wHxvK1DO
Can you use heat to ease the bend?
My bucket's 3/4" cutting edge is badly bent. I doubt if even my 6" vise will straighten it.Any ideas?
If you can email a pic to me I can give advice on easiest way. If it’s a bolt on edge most likely easiest way is to pull it and bend back with sledge.
Wow, you talk way too much. Just get to it
Seriously. Stupid shit
Where is the video on fixing a bend in the front flange that you mentioned at the end of this video. I don't see it on your channel.
@@kencecil697 for the cutting edge it’s the same process I used for the top edge. I think I did another video on the sides. Let me check for it.
@@kencecil697 ua-cam.com/video/PO-ImfYhiPI/v-deo.htmlsi=bEvRjEJ3wHxvK1DO
Can you use heat to ease the bend?
My bucket's 3/4" cutting edge is badly bent. I doubt if even my 6" vise will straighten it.
Any ideas?
If you can email a pic to me I can give advice on easiest way. If it’s a bolt on edge most likely easiest way is to pull it and bend back with sledge.
Wow, you talk way too much. Just get to it
Seriously. Stupid shit