After my extender got stuck out I pushed it back in but its not worked since have done some Google research and reading comments on this vid I pulled fuse number 50 in the boot left it out for 2 mins and 2 hours later it seems to be working again my car is a 2013 e class coupe old shape just a tip that may help someone who is stuck
@@Autofanas777 Hi 👋 thanks for watching my video. I would start with checking the fuse and make sure the drivers door registers when it’s open and closed too and the seat back is properly latched. If you have access to a diagnostic tester there may be a fault code stored which will help narrow down the fault. Could be a failed extender, hope this helps Charlie
Hi Have a look at the teeth on the extending arm to make sure none are missing. Try moving it around in case it’s jammed and push it back in with light to medium pressure so you don’t break anything. Failing that either take it back to whoever fitted it or if you fitted yourself you may need to take it to bits to see what’s happened. Hope this helps Charlie
@@brownsgarageltd thanx for the reply I gently pushed it back in flush and from now on will click my seat belt in before turning the ignition the extender good but so temperamental
@@brownsgarageltd my e class coupe is a 2013 do you know which fuse is for the seat belt extender just want to try pulling it for 30 secs tried number 15 but the pass side one still works si I'm thinking it's a different fuse ?
Hi, I'm having a small issue. I removed the rear quarter door card on my c207322, but cannot remove the extender. Did you pull the whole thing from the front and if so how didn't the eye break? I'm baffled ...
Hi The seatbelt is separate to the representer, meaning it shouldn’t need removing to take the seatbelt out. The seatbelt reel is further down the panel below the representer. Many thanks and I hope this helps
@@brownsgarageltd so i just have to take the rear panel out from the coupe ? Or do i have to pull the representer alittle bit and push the seatbelt button inside the pannel then take the pannel out , the reason i am asking this question is because i have an custommer tomorrow that needs his seatbelts changed
@@All2P Hi Yes take the rear panel, door card off. I would carefully pull out the extender arm unless you can easily unclip the belt from the extender.
So can you hear the motor running when you get in and shut the door, if yes then the actuator is fine and it’s the arm at fault. This can easily be replaced without removing the rear door cards. Hope this helps 😎
Yes no problem, the earliest I have is Monday the 7th June onwards. I would need the registration number to order the parts. It’s probably better to message the details. Many thanks Charlie
Hello, do you have any idea why my seat belt presenter for my A207 (Cabriolet) has this issue? 1) Passenger enter car, close the door, it extended. But went back in after less then 10 seconds, 2) Pressing the extend button on the middle of the aircon vent only extends the driver side, but passenger extender does not extend. 3) it should be extended for 1 minute before retracting in if seatbeat is not being worn. but my went back in not within the time.
Firstly I would check the seat belt warning is working ok, sometimes the buckle or wiring under the seat can cause a problem, I have changed passenger seat occupancy pads too but this fault normally puts the airbag light on. Hope this helps
@@brownsgarageltd hey, thank you so much for your reply. i do not know where to start diagnosis. because its strange. I suspect the occupancy pads too, but theres is no airbag light. i do not think buckle could cause that to happen though.
@@brownsgarageltd i have used my XENTRY and scan. under the Rear Control Module SG-FOND-> left extender it shows "POWER CONSUMPTION OF COMPONENT A10" is 0.000A whereas my right extender shows 92mA
After my extender got stuck out I pushed it back in but its not worked since have done some Google research and reading comments on this vid I pulled fuse number 50 in the boot left it out for 2 mins and 2 hours later it seems to be working again my car is a 2013 e class coupe old shape just a tip that may help someone who is stuck
How did you get the extender arm out before taking the panel off? and how much appoximately is the extender unit?
hi,not sure why but for no reasson today (drivers side) seatbelt extender didnt worked at all,was perfectly fine before.Any ideas? car 2012 e coupe
@@Autofanas777 Hi 👋 thanks for watching my video. I would start with checking the fuse and make sure the drivers door registers when it’s open and closed too and the seat back is properly latched. If you have access to a diagnostic tester there may be a fault code stored which will help narrow down the fault.
Could be a failed extender, hope this helps
Charlie
mine had a new mechanism 5 weeks ago but yesterday got stuck in the extended position and wont go back in any ideas for a troubleshooting fix
Hi
Have a look at the teeth on the extending arm to make sure none are missing. Try moving it around in case it’s jammed and push it back in with light to medium pressure so you don’t break anything.
Failing that either take it back to whoever fitted it or if you fitted yourself you may need to take it to bits to see what’s happened.
Hope this helps
Charlie
@@brownsgarageltd thanx for the reply I gently pushed it back in flush and from now on will click my seat belt in before turning the ignition the extender good but so temperamental
@@brownsgarageltd my e class coupe is a 2013 do you know which fuse is for the seat belt extender just want to try pulling it for 30 secs tried number 15 but the pass side one still works si I'm thinking it's a different fuse ?
Hi do you have the part number for the motor ? Thanks
Hi
There might be some variation with exact model , right feeder motor A2078600282
Left feeder motor A2078600182.
Hope this helps
Hi, I'm having a small issue. I removed the rear quarter door card on my c207322, but cannot remove the extender. Did you pull the whole thing from the front and if so how didn't the eye break? I'm baffled ...
Hi
Happy Nee Year.
Assuming it’s the same as the E class Cabriolet then yes it does pull out
Where is the rear passenger compartment control unite located
I have a question for an c class coupe, in order tot take the seatbelt off, do i need to remove the whole seatbelt representer?
Hi
The seatbelt is separate to the representer, meaning it shouldn’t need removing to take the seatbelt out.
The seatbelt reel is further down the panel below the representer.
Many thanks and I hope this helps
@@brownsgarageltd so i just have to take the rear panel out from the coupe ? Or do i have to pull the representer alittle bit and push the seatbelt button inside the pannel then take the pannel out , the reason i am asking this question is because i have an custommer tomorrow that needs his seatbelts changed
@@brownsgarageltdalso, do you think i can remove the panel while the seatbelt representer is intact?
@@All2P Hi
Yes take the rear panel, door card off. I would carefully pull out the extender arm unless you can easily unclip the belt from the extender.
Can u tell me the part no? Thanks
Mine is stuck out 24/7?
So can you hear the motor running when you get in and shut the door, if yes then the actuator is fine and it’s the arm at fault. This can easily be replaced without removing the rear door cards.
Hope this helps 😎
could i book my e class in with you please . need passenger re tractor fix .
Yes no problem, the earliest I have is Monday the 7th June onwards. I would need the registration number to order the parts. It’s probably better to message the details.
Many thanks
Charlie
@@brownsgarageltd 12th its a Saturday if ok with you .
My email
Andrewbyrne7724@gmail.com
@@brownsgarageltd my email
Andrewbyrne7724@gmail.com
@@andrewbyrne6505 Saturday the 12th is good for me.
I’ll email you tomorrow
Hello, do you have any idea why my seat belt presenter for my A207 (Cabriolet) has this issue?
1) Passenger enter car, close the door, it extended. But went back in after less then 10 seconds,
2) Pressing the extend button on the middle of the aircon vent only extends the driver side, but passenger extender does not extend.
3) it should be extended for 1 minute before retracting in if seatbeat is not being worn. but my went back in not within the time.
Firstly I would check the seat belt warning is working ok, sometimes the buckle or wiring under the seat can cause a problem, I have changed passenger seat occupancy pads too but this fault normally puts the airbag light on.
Hope this helps
@@brownsgarageltd hey, thank you so much for your reply.
i do not know where to start diagnosis. because its strange. I suspect the occupancy pads too, but theres is no airbag light.
i do not think buckle could cause that to happen though.
Hi mate. Did you fix it? Thanks
@@djextreme77 nope, i did not manage to fix it.
@@brownsgarageltd i have used my XENTRY and scan. under the Rear Control Module SG-FOND-> left extender it shows "POWER CONSUMPTION OF COMPONENT A10" is 0.000A whereas my right extender shows 92mA
How can anyone repair anything on a car with gloves on🤷♂️
Because you just wear them. Covid proof 🤜
@@brownsgarageltd covid 😂😂😂😂😂
Vertical video? WTF?
OMGWTFLOL 😂 I was having a bad phone day !!