Love your videos. When I do a chamfer on a model that already has it modeled I still use the debur tool. I just select the bottom edge just like you do here but set the width to 0mm and the height to something like 1mm to get the tool's tip below the edge and that works like a charm for me. I tried this too with a bit with a flat bottom and it compensates for the bottom radius.
Great explanation! Thank you! As an idea for the upcoming videos - setting up job with fixture modelled. Like part in a vice for example. It's not covered anywhere as I can see.
Love your videos. When I do a chamfer on a model that already has it modeled I still use the debur tool. I just select the bottom edge just like you do here but set the width to 0mm and the height to something like 1mm to get the tool's tip below the edge and that works like a charm for me. I tried this too with a bit with a flat bottom and it compensates for the bottom radius.
I tried that and it didn't do the right compensation. Must have done something wrong, I'll try again sometime
Great explanation! Thank you! As an idea for the upcoming videos - setting up job with fixture modelled. Like part in a vice for example. It's not covered anywhere as I can see.
Great suggestion! Thanks!