Trim Ring Install (recessed Lights)
Вставка
- Опубліковано 26 гру 2013
- VISIT....eddie-case.mykajabi.com/store for SUPER Detailed DIY Project Video Training!
In this video you are shown the proper way to install a recessed light fixture trim ring and baffle.
Short, simple, and got the job done. Love videos like this. ❤
Can’t tell you how helpful this was! Thank you
I was about to throw away some trim rings / bezels because I thought they were too long but thought I would double check. Thanks for video!
Just what I needed to know -- thank you for this unique video regards trim ring install on older trim units
Thank you very much - just what I was looking for!
Thank you! That was exactly what I needed to see!
Was helpful, thank you. Looking everywhere for this video
Super helpful. Thank you!👍
Great video! Exactly what I needed!
Some of my springs won’t tighten it to the ceiling. It dangles down. And I’ve pushed the inside canister as far as it will go up
Thank you =)
Thanks
Very helpful! Is there a way to replace just the outer ring without having to mess with the entire housing (baffle and mount springs)? I just don’t like the color of my current outer rings
The springs don't go in anywhere near that easily.
I notice that you adjusted the socket mount above that screw that sticks through the side. The instructions that came with the halo H71CAT make it seem like this is not intended, though it is not very clear. Do you know if this is okay?
what happens when the springs get sprung?
If only the painters I hired had consulted this video, instead they just tugged out the trim ring and stretched out the springs, leaving them dangling.
zz thats annoying. I tell you finding good contractors is a chore
what do you guys do if cavity is fully extended and spring is still too long - any tricks other than macgyver
commenting, to follow in case you get an answer. I'm having the same issue.
@@SharonStroudBroussard i just stretched the spring until it was tightand twisted it. Might be a pita to do a repair after the fact but that's pretty rare.
Mine aren't staying centered when I add the bukb
Of course the screw that adjust the height of the can on mine is stripped...
A DIY video probably should not instruct people to stick their hands inside an electrically hot light fixture.
just saying but if you get shocked doing this thats natural selection
@@husher5142 And if someone dies because of they followed the dangerous instructions of a DIY video, and the creator of the video gets sued by the family, loses everything, and dies of starvation, that's natural selection too. Just sayin'.