It was quick! Look up 6:30. It is essentially the same process as removing the factory unit but in reverse. We also have a color photo pdf of the instructions if you need it! Just reach out to us on our website!
It just depends on your goals for the car. We would suggest the intercooler if you plan on adding some other mods, the intercooler would support anything you really do.
Just installed mine today. Worst part of install was the million screws holding on the bumper. . For anyone not trying to remove their wheels and or only have ramps, you can do this without removing the wheels. Just turn the wheel, and you can access everything, a little tighter than if the wheels were off but it can be done, bumper comes off pretty easy once everything is free. Just take your time and watch this video step By step and you will have no issues.
@@TTrident660 just got the inter cooler today. I’m looking at getting the zzp throttle body but not sure what charge pipes that would be best. Either injen $300 or mitshimoto $500 :/ any input on this? I highly appreciate it!
Okay I’m looking to replace the grille only. Is it necessary ro remove the bumper to replace the grille??? I know its a completely different topic im asking about
Need more V6 content. It’s difficult to find good stuff for them. Overkill and edelbrock make a Supercharger kit, borla makes a few exhaust for them but that’s about all I can find.
Disconnect the battery for about 5 minutes. This will reset the system and should clear that up. Sometimes the system will see a fault when they are unplugged and that causes them to stay on. Disconnecting the battery should clear that up.
We did not dyno this car once the mods were installed. However Mishimoto claims that the intercooler can improve the power by about 15rwhp and 12 ft-lbs of torque.
Great job on this.
Thank you.
I love that new gauge!
The P3 Gauge works very well. Check it out on Phastek.com!
Do you have an install video for that boost gauge
Great video 🎰🥂 we definitely say do more installs 🔥🔥🔥
You didn't show how you actually installed the new intercooler...
It was quick! Look up 6:30. It is essentially the same process as removing the factory unit but in reverse. We also have a color photo pdf of the instructions if you need it! Just reach out to us on our website!
I have a 2016 2.0, should I get an inter cooler? I just installed a injen cold air intake. Does a intercooler help as well?
It just depends on your goals for the car. We would suggest the intercooler if you plan on adding some other mods, the intercooler would support anything you really do.
Love what yall do, i have bought and will continue to my products from yall. Just can’t get into the 2.0 stuff. I respect it though.
Thank you for the support!
Just installed mine today. Worst part of install was the million screws holding on the bumper. . For anyone not trying to remove their wheels and or only have ramps, you can do this without removing the wheels. Just turn the wheel, and you can access everything, a little tighter than if the wheels were off but it can be done, bumper comes off pretty easy once everything is free. Just take your time and watch this video step
By step and you will have no issues.
Did you get a check engine light with this?
@@hunterrocks24 no check engine
@@TTrident660 how did u pull the intercool out? waws it from the bottom? if so how with no room?
@@eztrash4903 plenty of room to do it from the bottom. After I disconnected the 2 bolts holding the AC condenser. It has plenty of room to get it out.
@@TTrident660 just got the inter cooler today. I’m looking at getting the zzp throttle body but not sure what charge pipes that would be best. Either injen $300 or mitshimoto $500 :/ any input on this? I highly appreciate it!
Do you need to get the vehicle tuned after this? Last mod I did was the exhaust, then got it tuned. However, will I need to get it tuned again?
Do you need to get tuned after installing it?
I can’t get the damn charge pipes off
Okay I’m looking to replace the grille only. Is it necessary ro remove the bumper to replace the grille??? I know its a completely different topic im asking about
Yes, to replace the front grille the bumper will have to come off. The grille will have to be removed from the backside of the bumper.
where and how can i install a tow hook on this car?
Need more V6 content. It’s difficult to find good stuff for them. Overkill and edelbrock make a Supercharger kit, borla makes a few exhaust for them but that’s about all I can find.
We are working on some V6 stuff. Just trying to get manufacturers on board with it. Thanks for the suggestion!
Does the intercooler hook up to the factory pipes?
Yes, if you choose to reuse the factory charge pipes for a while you can do that.
I did all the steps but after the installed the radiator fan stays on even when I turn the car off
Disconnect the battery for about 5 minutes. This will reset the system and should clear that up. Sometimes the system will see a fault when they are unplugged and that causes them to stay on. Disconnecting the battery should clear that up.
@@PhastekPerformance do you also install your mods for customers?
i have a 2020 2.0 camaro i was hoping to find someone who lives near to help me do some mods. would love the guidance and friendship
Where ya located? Looking for someone in Greensboro NC area with a 2.0 LTG.
@@Wowz4me Indiana
What numbers is it putting up?
We did not dyno this car once the mods were installed. However Mishimoto claims that the intercooler can improve the power by about 15rwhp and 12 ft-lbs of torque.
I got one brand new closed box mishimoto intercooler if interested. Hit me up
2019 turbo FORD camaro? a FORD?
What was said was Turbo 4 but we can see where it might sound a little like Ford.