Techno Toy Tuning AW11 MR2 Coilovers Review and Install

A look at the Techno Toy Tuning DIY coilover kit and the basics of installation. I am not sponsored by or affiliated with this company.
technotoytunin...
Be sure to measure the diameter of your strut rods and include that in a note with the order to be sure you get the proper spring tops. T3 does have 20mm spring tops to resolve the issue noted at the end of this video.

[@ayushjeevan4612]

Thanks for this literally the only good video on these

[@53Aries]

Thanks for the kind words. I wish I had done a better job as I didn't realize how many people would actually want this info.

[@ayushjeevan4612]

@Matthew Swanger ...well it still helped A LOT and was super useful even before I bought a set (also subbed)

[@RUNFREE357]

Wicked video, looks awesome. Looking into these for my aw11. Godspeed is near the same price and ive heard theyre ok for what they cost.

[@53Aries]

I would recommend these, they are really good and T3's support is amazing. All my tiny nit picking issues were resolved within 2 days I think. Thanks for watching!

[@SneakHeat23]

What was wrong with it? I’m having the same problem.

[@wholespeed]

Great video...Bueller...Bueller...Bueller

[@phillipferrer4668]

Did you need any spacers between the top hat of the spring and the top strut mount ?

[@53Aries]

I kinda remember a spacer there, but it's been years and I honestly can't say. Sorry.

[@phillipferrer4668]

No worries thanks for the reply 🙏

[@mexpb8646]

how much can you lift it with that set-up? Great vid btw

[@53Aries]

Mex Pb you could lift tons, basically the full length of the threaded adjuster. The only thing that would limit you would be the length of your strut, because at some point the strut just won't go up anymore. If you're actually looking at lifting an AW11 I'd say you could lift 1 to 2" over factory before the strut is "topped" out. You could go higher by modifying the strut housing to raise the strut insert, basically make the strut housing longer and put a spacer to fill the gap under the insert. A much easier way to lift that will effect suspension geometry less is putting a spacer plate between the upper strut mount and chassis.

[@mexpb8646]

Thanks! yeah I'm just researching different options for my aw11 I may lift it if I need to for offroad/rally use so Ill think about those two options, thankyou.