2011 International 4300 Electric Problem, Abs brake light, Limp mode, Truck Wash fail, Maxxforce DT

Washed our 2011 International 4300 and it died right at the truck wash bay. We have had similar "brake" problem on the road, where it would start flashing all kind of lights at us, make us stop and wouldn't move. All that was after I replaced master brake cylinder, but I could never figure out what causes it out of the blue, this time it revealed that all that was a small rubber seal on connector. Watch and comment.

[@46REBORN]

Pressure problem on my 2004 international. Truck kept shutting off. Thanks for sharing this information. Very helpful 🙏🏾

[@toniakislyak9213]

Paul, my truck has the abs light on and would run good for about 5 minutes and then wont go past 20mph and then you would cycle the truck on and off and your good for another 5 minutes. Here are the active codes: SPN 4765, SPN 3251, SPN 3242.

[@rootkitxx]

Hydraulic or air brakes?

[@hunternovak7241]

Great explanation ! Thank you

[@RodneyPerformance]

My truck has the abs light on and would run good for about 5 minutes and then wont go past 20mph and then you would cycle the truck on and off and your good for another 5 minutes

[@rootkitxx]

Thats a limp mode. You have electrical brake probl
Check codes (I have another video on it)

[@alialdaffaie1752]

I have the problem to it seems like the sensor wire needs to be replaced 😕 🙃

[@aminosaminos3656]

Hello sir thank you for the video
Please I’m going to buy same truck what I should to check ? What your experience with max force engine? I heard a lot of a bad reviews?
Thank you in advance

[@picasso2445]

Don't buy with Maxxforce, unless you know how to wrench. International are great tough trucks, but Maxxfroce engine is problematic. They are cheap for a reason. Buy with Cummins or older dt466 engine.

[@aminosaminos3656]

@@picasso2445 thank you

[@robbieperlick7683]

Water prob got to the circut or something

[@millionairepresident1940]

Would this problem cause your truck to not start at all...ive been trying to get mine started for a week..all my break lights are flashing. chiming. And will not activate start.

[@rootkitxx]

My brake lights flashed too, so very possible. What are your codes? (I have another video on pulling codes with no tools)