Driveline Vibration Diag and Repair
Вставка
- Опубліковано 5 тра 2022
- This L400 Delica had a high speed vibration that could be felt through the entire van. While often vibrations are caused by out of balance wheels, a "high speed" or high frequency vibration is more commonly a drive train issue.
Parts Affiliate Links:
Drive Shaft U-Joint Front (L300/L400) - amzn.to/3Zdb3cA
Drive Shaft U-Joint Rear (L300/L400) - amzn.to/45PqSZu - Авто та транспорт
Thank you
Thank you!
nice job!
Cold stari issue is front seal on inj pump. I also had a glow plug relay fail, that was double the smoke.
That's what I figure as well. It's on the list of things to do... the ever growing never shrinking list....
Nice...thanks 4info..where's your shop..I have same L400 space gear no issues..
But learning alot 4da Future..Thanks great work..
What a very very nice steering wheel you have! Know what model is that one? Also, you should apply grease into that tubby thing on the joint.
That steering came in an L300 bought years ago and has been swapped through each new van since then. Honestly not sure what type of wheel it is.
Thanks for this video. Got this problem right now. Can we source the universal joints in any regurlar parts store in canada?
I believe the Montero drive shaft u-joint is a cross over.
My “Sport” light on the dash also flashes, same as this Delica. Is that because the shocks were replaced with non-ECS, or maybe the actuators were removed so there is an open circuit because the plugs aren’t connected? I’d like to stop my light blinking if possible.
Hi Ronan, if the adjustable shocks have been removed you will likely get a fault thrown for it. If the system has been removed it may be possible to jumper the plugs however I cannot say for sure as I have not attempted to fix a blinking sport mode light yet. In saying that if the system is gone it may be easiest to just remove the bulb from the cluster... It is redundant now that system is gone anyways.
Great video but the music is wayyy too loud to hear you properly
Hi Dusty, glad you like it.
I have the music set 22db lower than my dialog when I am speaking anything of importance which is 2bd more than normally recommended. May I ask what device you are watching on and which specific areas are hard to hear so I know for the future?
Nice hair cut bro
Cheers. The locks had to go after the gear oil explosion ;)
Oh I remember I saw the video the other day.how did that happen?Air line popped out?
Are you planning to make a movie of the white smoke from the exhaust pipe? Or is that just the moisture?
@@applepen6428 I designed a pneumatic fluid transfer tool but wasn't paying attention during use, and over pressurized it causing the entire bottle to explode.
Glow plug and injector video will be coming in a few weeks.