Hi, all flash reads always has to be same/identical when you read it and compare with hex editor ? My flash reads are different, just checked, eeproms are equal/identical, but flash reads has differents ?!?! :(((
@@YOYODiagnostic I read msd87.2 conti ecm with trasdata 9.004 (made from ktag / russian reworked premium clone) i read in boot mode , i did read separated flash, eeprom, but all 4 flash reads are different in hex editor . Epproms are full same. What can be problem?
Can kess read tricore? I have kess and ktag but my MSD80 DME is from n53 and ktag I can't get to list the n53 only with kess. Is BDM / tricore also possible to do with kess?? Awesome channel you helped me fix my Chinese SD cards!!
Nice. I'm beginner. Can I ask?: Can I Read by tricore way EDC17CP14 by Kess v2 clone? Where in this files are Tprot, maps for engine are located? Is it ok to edit these read files with hexaeditor, or with Davinci SW? Will it work, if I Write edited files by tricore Kess v2 clone by tricore protocol 198, or by Kess v2 clone OBD protocol 501? Thank You for any advice.
Exellent😊
👍
Hi, all flash reads always has to be same/identical when you read it and compare with hex editor ? My flash reads are different, just checked, eeproms are equal/identical, but flash reads has differents ?!?! :(((
Hi.
It must be the same. If you read it in BDM write in BDM
@@YOYODiagnostic
I read msd87.2 conti ecm with trasdata 9.004 (made from ktag / russian reworked premium clone) i read in boot mode , i did read separated flash, eeprom, but all 4 flash reads are different in hex editor . Epproms are full same. What can be problem?
@@duckla7488
Both readings are the same size ?
@@YOYODiagnostic yes, size same, hex editor finds differents in flash reads, but in eeprom reads no different :s
@@duckla7488
Send me Mail with Dump ( yoyo.pc86@gmail.com.)
can you share a copy of that infineon mcu datasheet? or a hint on where you might have found it?
Jumper on adapter closed or open chain?
Can kess read tricore? I have kess and ktag but my MSD80 DME is from n53 and ktag I can't get to list the n53 only with kess.
Is BDM / tricore also possible to do with kess??
Awesome channel you helped me fix my Chinese SD cards!!
Nice. I'm beginner. Can I ask?:
Can I Read by tricore way EDC17CP14 by Kess v2 clone?
Where in this files are Tprot, maps for engine are located?
Is it ok to edit these read files with hexaeditor, or with Davinci SW?
Will it work, if I Write edited files by tricore Kess v2 clone by tricore protocol 198, or by Kess v2 clone OBD protocol 501?
Thank You for any advice.
Is this an original or a clone?
❤❤
👍
Toyota viedeo pin out sir