How To Change A Flat Tire

How To Change A Flat Tire
SAVE the video for later, COMMENT with any questions you have and FOLLOW for more on every step of the car flipping process!
👇FOLLOW me on INSTAGRAM: @benflipscars👇
/ benflipscars
👇FOLLOW me on TIKTOK: @benflipscars👇
/ benflipscars
STEP 1:
First locate your spare tire and tools.
Will either be:
In the spare tire well
Underneath the back of the car
Attached to the boot of the car
And the tools should either be with the tire or under a flap / panel somewhere.
STEP 2:
Loosen the nuts slightly that are holding on the tire. You want to do this before you lift the car off the ground.
If the nuts are too tight apply some WD-40. Then try standing on the tool, or using something long to increase your leverage.
STEP 3:
Figure out where you are supposed to jack the car up from and begin raising the car from that point. Don’t try it from anywhere else as you’ll damage the car. Raise it until the tire is just off the ground.
STEP 4:
Undo the nuts the rest of the way and remove the tire. Then simply place the new tire on and begin to tighten the nuts until they hold the tire flush but are not yet tight.
STEP 5:
Whilst the tire is in the air, tighten the nuts as much as possible in a star patten.
STEP 6:
Lower the car back down and then tighten the nuts as tight as you can by hand with the included tool in a star pattern.
STEP 7:
Place the flat tire wherever you got the spare from and put you tools back in place, and you’re good to go!
#fixingcars #carflipping #flippingcars