Check the wiring harness first i went through everything trying to fix it and it was just the wire that provides power to the fuel pump had got to hot and didn't have a good connection
Started my bike last time in January 2019 for about 10 min then tried to start it today pump wont prime getting codes 12,13,14,15 they are injector codes tested all injectors they are good all fuses are good all relays are good only thing I haven't checked was the ignition diode do you think that is the prob? .... but why am I getting the codes
I made a second video you also need to look at that one because it may not be the diode it may be the wiring harness. Check that first before you replace the diode. And i just order a new ignition and key from Amazon
Thank u.
Good video, thanks for posting. Lots of potential fault points. Easier than chasing wires for someone new to the bike.
My bike done this today, Fuel pump won't prime but turns over
Check the wiring harness first i went through everything trying to fix it and it was just the wire that provides power to the fuel pump had got to hot and didn't have a good connection
Hey i got a 2002 cbr954 and its doing the same thing. Did your light come on when u turned the key on?
Which light?
Its supposed to have 9volt on the pink cable not 12 its a signa to the computer. You can use a 9volt battery to fool the computer
Q me dida es el diodo q lleva
Started my bike last time in January 2019 for about 10 min then tried to start it today pump wont prime getting codes 12,13,14,15 they are injector codes tested all injectors they are good all fuses are good all relays are good only thing I haven't checked was the ignition diode do you think that is the prob? .... but why am I getting the codes
You always have to make sure the pump is getting power the injectors in these bikes dont go bad too often
hey thanks for the video. So did you end up replacing the diode and if so where did you order one from? thnk you
I made a second video you also need to look at that one because it may not be the diode it may be the wiring harness. Check that first before you replace the diode. And i just order a new ignition and key from Amazon