How to Service a YD25 Navara

Поділитися
Вставка
  • Опубліковано 24 кві 2022
  • Here is how to perform a basic service on a YD25 Navara. In this video I show how to change the Air, Oil and Fuel Filters along with changing the oil on a YD25 Navara. This is an easy job and should take about 1-2 hours, and is a great way to get familiar with your car and your engine.
    Here's a link to Oil and Air Filter ebay.us/3aPHCf
    Here's a link to Fuel Filter ebay.us/hW0LBN
    When you click on the above link and make a purchase, this can result in myself earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
    If you have any questions please use the comment section below.
    Music ~ "Lullaby" by Jaukim Karud
  • Авто та транспорт

КОМЕНТАРІ • 62

  • @dylanfarquhar3473
    @dylanfarquhar3473 2 роки тому +3

    Awesome video mate! Very detailed and helpful

  • @busayaphatchinchaibun6473
    @busayaphatchinchaibun6473 2 роки тому +1

    Thanks for the video, I gained some knowledge on how to service my D22!

  • @lukebrown248
    @lukebrown248 3 місяці тому +1

    Nice video mate
    Straight to the point and no useless discussions or shit jokes.
    Awesome

  • @4WheelingInNSW
    @4WheelingInNSW 2 роки тому +2

    I just did a service the same and OMG did it take some priming .... filled the diesel filter with diesel and everything and must’ve pumped the primer 100 times literally, ended up with a forearm that looked like Popeye - in the end I had to crack the pipe off down near the pump and bleed the air out down there, prick of a job but got there in the end. Cheers and thanks for sharing 😉👍👍

    • @ReubsModifications
      @ReubsModifications  2 роки тому +1

      Yeah but of a mission to prime them, I’ve had to crack the lines before too. Sometimes you get lucky sometimes you don’t 😂

    • @4WheelingInNSW
      @4WheelingInNSW 2 роки тому

      @@ReubsModifications I even plugged the lines where they push onto the filter however that didn’t seem to stop it sucking air into the lines. I might trying clamping them next time with vice grips maybe 👍

  • @dean6267
    @dean6267 2 роки тому +6

    A Diesel mechanic showed me a great way to service the fuel filter and that is to remove both fuel lines from the filter assembly then remove the two bolts, then turn it upside down bolt it back up then remove the the filter. Then you can reassemble new filter without double handling the filter. Turn filter assembly back the right way attach fuel lines and prime away.

    • @ReubsModifications
      @ReubsModifications  2 роки тому +1

      That’s an awesome tip, thanks for sharing🤙🏻 really appreciate when people are able to share that type of information👍🏻

    • @melburnian1979
      @melburnian1979 2 місяці тому +1

      Absolute pro tip! I just did mine for first time this way and so easy especially because i dont have a bench vice to hold the filter! Cheers guys

  • @njingaradebe9652
    @njingaradebe9652 9 місяців тому +1

    Thank you

  • @lethaloutdoors001
    @lethaloutdoors001 2 роки тому +1

    Nice video!

  • @leondejuda7602
    @leondejuda7602 3 місяці тому +1

    Exelente

  • @milletsaji311
    @milletsaji311 Рік тому +1

    Hi mate, your videos are very helpful and well explained cheers,
    i have an issue with my d22 navara, my oil warning light is not turning on when the ignition turns up, it happened after an oil change, and just one time came on after, then never tuned on, what might be the reason for this? Where is its sensor located?
    Please give me a reply if you keen
    Thanks

    • @ReubsModifications
      @ReubsModifications  Рік тому

      hey mate, I'm pretty sure the oil warning light is only meant to turn on if there is an issue with the oil pressure. If your oil pressure is operating as normal the light should not be on.

  • @unclecharlo8518
    @unclecharlo8518 8 місяців тому +2

    I want to know what causes d fluttering when I r in3 gear

    • @ReubsModifications
      @ReubsModifications  8 місяців тому

      Are you asking about turbo flutter? Or is there another issue?

  • @reganbright7047
    @reganbright7047 2 роки тому +1

    For your service manual did you just print off an online version for the yd25? or is there a certain one you picked up, if so which one did you use? Cheers

    • @ReubsModifications
      @ReubsModifications  2 роки тому

      We have a subscription to Scribd where you can find all sorts of manuals. We found a Nissan Navara ebook and printed off most mechanical and some electrical 👍🏻

  • @Fi1del
    @Fi1del Рік тому +1

    hi does this have the common rail version or the vp44 rotary injector pump version ? which one is better in your opinion im looking to get a navara very soon going to trade my mk 1 pajero in

    • @ReubsModifications
      @ReubsModifications  Рік тому +1

      This is the common rail version with the 2.5, I have the Direct Injection 3.0L with the VP44. Both have their benefits and both engines are becoming more popular with some people doing some really impressive work and getting good power out of them. I prefer the DI as its a little bit easier for people to work on as there's less electronics. Both cars are almost identical otherwise.

  • @unstopableguy1
    @unstopableguy1 Рік тому +1

    Hey mate can you send me the link to where I can get that owners technical manual? Is there somewhere I can get the pdf for free ?

    • @ReubsModifications
      @ReubsModifications  Рік тому

      I'm not sure where you'd be able to get it for free, I got it from a website called scribd, but that website has a subscription fee.

  • @joshbender419
    @joshbender419 2 роки тому +1

    Hey mate what intercooler is that ?

    • @ReubsModifications
      @ReubsModifications  2 роки тому

      Hey mate it’s from AdRad, factory style replacement with welded tanks instead of the crimp style that fails. I’ll have an install video out for it soon 👍🏻

  • @KajouAyame
    @KajouAyame 8 місяців тому

    Hi, I have a question, why does mine have 2 fuel filters? One is short and one is a bit longer. The handpump is connected to the short one and the longer one is connected to the cable like yours..

    • @ReubsModifications
      @ReubsModifications  8 місяців тому

      Likely that you have a primary and a secondary filter, they will have different sized filter screens inside. If not a secondary filter than id say it’s a water separator👍🏻

  • @billoracle7761
    @billoracle7761 Рік тому +2

    What oil do you use?

  • @timmyCOD
    @timmyCOD 2 роки тому +1

    fck me, thats a clean ass engine bay! Can you make a video next on how to clean it? ahah

    • @ReubsModifications
      @ReubsModifications  2 роки тому

      It’s an immaculate car, it’s even been all the way around Australia so it’s seen plenty of dust. I think the trick is keeping them out of mud if you can, although there are some good products for that. Might make a engine bay video once mine is back on the tracks 👍🏻

  • @stephjacobson3697
    @stephjacobson3697 2 роки тому +1

    In my yd25 got water in my intake the other day :( never good

  • @4WheelingInNSW
    @4WheelingInNSW Рік тому +1

    I just noticed you didn’t take the hoses off the filter before removing it …. you reckon just leave them on there eh and unscrew the filter ?
    Maybe that’s what I did wrong causing air to suck in 🤔🤔🤔

    • @ReubsModifications
      @ReubsModifications  Рік тому +1

      My patrol had trouble starting a couple times after I changed the fuel filter, could just be the system working air bubbles out. Id try priming the filter whenever you have issues and Id say there's a good chance this problem will go away pretty soon. I dont think there would be much difference between taking the hoses off or leaving them on, the diesel will come out anyway.

    • @4WheelingInNSW
      @4WheelingInNSW Рік тому +1

      @@ReubsModifications yeah thanks bud.
      I changed it like you did and still had air get in the lines … friggin’ pain in the backside, started it yesterday and was still struggling with it today 🤣 end up having to pressurise the fuel tank with a compressor and crack the line a few times to get the air out.
      I ended up putting a small ball pump, like used on outboard motor fuel tanks, on the inlet hose and it may’ve made it a little easier to prime, not really sure. The factory primer on top of the fuel filter is as useful as boobs on a bull 🤣.
      I don’t think it helped the car was nose up and the tank was between 1/4 and 1/2 full - was taking forever to prime.
      Geez there was some crap in the old filter OMG !!! I think that’s what may’ve been causing the surging I was asking you about - don’t think it was my NPS after all, will take for a good uphill run and test it out 👍 cheers mate and I appreciate your help and advice - long live the Nav’ mate #navlife 🤣

    • @ReubsModifications
      @ReubsModifications  Рік тому +1

      @@4WheelingInNSW glad you have it sorted, good thing the filter caught it. Imagine the headache of replacing the injector pump 😂

    • @4WheelingInNSW
      @4WheelingInNSW Рік тому

      @@ReubsModifications insert over left shoulder finger snap here> “oh don’t go there gurlfriend” 🤣🤣🤣🤣
      Gives me anxiety just thinking about it 🤦🏻‍♂️

    • @4WheelingInNSW
      @4WheelingInNSW Рік тому +1

      @@ReubsModifications after all that, turns out I put the Z322 on and it should’ve been Z1000 …. 🤦🏻‍♂️🤦🏻‍♂️
      Here we go again 🤣😳🤪

  • @thiccniqaps4501
    @thiccniqaps4501 2 роки тому +2

    Where’s the SAS vid😢

    • @ReubsModifications
      @ReubsModifications  2 роки тому +3

      Got plenty done over these long weekends so my next upload will be SAS pt4 🤙🏻

  • @klearman9612
    @klearman9612 7 місяців тому +1

    Bro my trucks not starting after installing fuel filter

    • @ReubsModifications
      @ReubsModifications  7 місяців тому

      Have you primed the pump until it becomes firm?

    • @klearman9612
      @klearman9612 7 місяців тому +1

      Primed it for like 10 mins bro

    • @klearman9612
      @klearman9612 7 місяців тому +1

      Do you have to fill the filter with diesel first before install

    • @ReubsModifications
      @ReubsModifications  7 місяців тому

      @@klearman9612 yes that helps, you can also undo one of the injectors and crank the engine until fuel comes out the injector

  • @bloomfield9207
    @bloomfield9207 Рік тому +1

    bro, where’s salon filter?😢

    • @ReubsModifications
      @ReubsModifications  Рік тому

      The d22s didn't come with a cabin filter unfortunately. I'd say that there is probably a way to fit a filter into the AC ducting.

  • @dinkybacon_9686
    @dinkybacon_9686 2 роки тому +1

    Always first 🤣🤣🤣

    • @ReubsModifications
      @ReubsModifications  2 роки тому +1

      Haha always 👍🏻 next upload will be the SAS, got quite a bit done over these long weekends

    • @dinkybacon_9686
      @dinkybacon_9686 2 роки тому +1

      @@ReubsModifications great to hear cant wait to u post a video of you taking it for a weekend away and seeing how it performs

    • @ReubsModifications
      @ReubsModifications  2 роки тому +1

      @@dinkybacon_9686 bloody oath, Matt from Crawl Customs just took his out for a trip and said it just needs a little tweaking 🤙🏻

    • @dinkybacon_9686
      @dinkybacon_9686 2 роки тому

      @@ReubsModifications nice bro 🤙🤙🤙

  • @manuelithoodiaz2300
    @manuelithoodiaz2300 Рік тому +1

    La otra es zd30 ??

  • @patriziusthirlwall4800
    @patriziusthirlwall4800 2 роки тому

    𝐩яⓞ𝓂𝓞Ş𝐦 🤣