2015 Ford Transit 250 ABS, Traction control, Hill start assist repair
Вставка
- Опубліковано 27 бер 2022
- You can support Ukraine financially in war against Nazi Russia through these trusted foundations:
United 24 u24.gov.ua/
Serhiy Prytula Charity Foundation
prytulafoundation.org/en
#tryityourself #doityourself #Ford #abs
Become a member to get exclusive access to perks!
/ @vasylgladun
Sensor Ford part number
KK3Z-2C190-E - Навчання та стиль
this guy is very good ...very honest in his methods...
Your video was by far better than all the others on this problem!
Thank you.
I had the same problem on my 2018 transit. It affected my cruise control also. Cleaned and working perfectly. Thank you for your video. A++++++
Thank you for your comment.
brilliant video and many thanks
Very good information I had the same problem and thanks to you I fix it my self thank you 🙏🏻
You are welcome.
Good job man. Thanks for the video, seems easy enough to repair
Little bit tricky because of the location but not too bad. Thank you for the comment.
Thank you😊
Same warning lights on my 2014 Transit Connect. I’ll be under it tomorrow. Great call to investigate further before going back to the dealer.
Thank you. Good luck to you.
Did it work for you
Very informative great content
Thank you
My man, I appreciate the video. Have same problem. I took the van to the shop they ran diagnostics and swapped sensors from one side to the other, bit that didn't fix anything. I had to pull the van out of the ship due to the next day scheduled job. They said bring it back and we will continue diagnostics at $110 an/h. I will be checking the wiring on that sensors and will be back to let you know. Seems like everyone has the same problem with left side. Let me know if anyone had experienced anything different. Thanks again.
Good luck.
Thx it worked for me really easy
Thank you for the feedback.
Thank you for this video!
You are welcome
Before you soldered the wire, you may have been able to put a small piece of heat shrink tubing on the wire, pushed it down out of the way while you soldered and then moved the tubing up over the solder joint and heat shrinked it.
Great video. I have a 2016 Transit Connect and have had the exact same problem. In fact, I have it now. It is flakey. It works one minute and then you get the trouble lights about the ABS and hill assist start.
The wire may have had rodent damage. Rodents are serious problems with vehicles. They need to stop putting soy in the wire insulation. This should be a class action lawsuit against all car manufacturers who use soy in wire insulation. Worst idea ever.
Totally agree about heat shrink, but at the time of the repair I didn't have any on hand, as you can see from the video I thought it was just an easy swap with a bad sensor.
I have that light.i replace both rear sensor and still have dash lights on.glad you made the video,Il go back and chk the wiring.the van drove fine so i was just drive it with the annoying alert every start up.
I hope you will locate the problem. Good luck.
@@VasylGladun thks
@@Da305Alive did you find the issue?
Could be the abs tuning ring
Could be the abs tuning ring
Pleased ive watched this I will give it a try thanks
Good luck!
Good work amigo
Thank you
Thanks for your video it is real halp full a++++❤
You are welcome
help where is parking aid sensor located on 2015 ford transit connect?
Nice
Thanks
I had these lights come out too. All i did was push the switch under the dashboard all the way with my finger. This switch is on driver side, and the brake handle pushes on it when the foot brake is in normal resting position.
I don't think this would work in my case with the cut wire.
What switch, I can’t seem to find it
@@Monotone1118follow the brake lever up to the under part of the dashboard. Youll see a push-in/out switch
👍
over a half million miles? wow
Would a bad wheel speed sensor cause abs pump to run continuously killing my battery?
Looks like I've learned something new today, I never heard about it before, but according to Google is possible
Mouse chew through wire. What's the name of the sensor?
I have a 2015 Ford Transit 150 cargo van with only 53000 miles on it it's been babyed since i bought it new and now I have a warning light coming on that says ABS BRAKE POWER BOOSTER FAILURE SERVICE IMMEDIATELY and when I push the brake pedal its hard to push and the van doesn't want to stop like it should. Taking it to the Ford dealership Monday.
If you don't mind, can you please share the results after visit to Ford dealership
@@VasylGladun ok
What is the Ford part number for that new sensor you installed?
In description
Thank you, sir.
Which OBD code was firing?
I didn't check the codes on this one since Ford pointed out a faulty sensor for me.
How do I know which one I have to repair ??
In my case it was easier because right before the repair I had my van diagnosed at Ford dealership. In your case, you have two options, the cheaper one visually inspect all wires on all four ABS sensors, if you don't see anything, go to plan b which is buying one ABS sensor and replacing on every position until you hit the broken one.
How do i know witch sensor it's not working??
I don't think you can find out without special diagnostic tool.
Do you have the sensor part number by any chance . Thanks
KK3Z-2C190-E
Thanks but my problem come from the Tone Wheel on the rear right side . Did you ever had this problem ? @@VasylGladun
No, I didn't have that problem.
{