HOW TO REPLACE REAR WHEEL BEARING ON A 2010 - 2016 CADILLAC SRX

Поділитися
Вставка
  • Опубліковано 25 сер 2022
  • HOW TO CHANGE REAR WHEEL BEARING ON A 2010 2011 2012 2013 2014 2015 2016 CADILLAC SRX
    PLEASE SUBSCRIBE!!!
    #CADILLAC #CADILLACSRX #CADILLACSRXWHEELBEARING
    #wheelbearing
    HOW TO REPLACE WHEEL BEARING ON A 2016 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2010 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2012 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2011 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2014 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2013 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2015 CADILLAC SRX
    HOW TO CHANGE WHEEL BEARING ON A 2016 CADILLAC SRX
    WHERE IS ABS BRAKE SENSOR ON A CADILLAC SRX
    BRAKE SENSOR LOCATION
    BRAKE SENSOR

КОМЕНТАРІ • 24

  • @raymundomunoz2309
    @raymundomunoz2309 Рік тому +1

    Thank you for this. My 11’ SRX is NOT AWD and thus made it a bit easier to accomplish this job. I did NOT take off ABS sensor knowing I ran the risk of braking it. Also, I did NOT take off the e-brake stuff. The bearing came off with WD-40 a lot of hammering, tapping and some patience and it finally came off. On a scale of 1 to 10 I would say this is a 3-4 in terms of difficulty.

  • @mattmsl7

    Rubber mallet? Those don’t come off without a torch and air hammer up where I live. They still pay the same flat rate down there?

  • @carlbernngl

    Can you post a pic of where to place the jack? Thanks

  • @alaylabond2001

    What year is this? Is this awd I have a 2013 and it’s pretty rusty my mechanic using wd40 but didn’t let it sit long doing a lot of hammering

  • @gmartgo
    @gmartgo Рік тому

    Not necessary to take the whole e brake assembly apart. It all comes off together at once with the wheel bearing hub. That doubled the work involved.

  • @SKRILLA4DBD
    @SKRILLA4DBD Рік тому

    So did you have to push the clip out from between the frame first before disconnecting? For the sensor?

  • @jimw.4438
    @jimw.4438 Рік тому +4

    You should have taken the wheel sensor out first and you probably would not have broken it. Also have done wheel bearings before and not had to take apart the emergency brakes.

  • @djjammindave
    @djjammindave Рік тому

    IF IT WAS BROKEN, YOU SHOULD HAD AN ABS LIGHT ON IN THE DASHBOARD. THAT LINE SHOULD HAVE BEEN REMOVED PREVIOUS TO TAKE THE WHEEL BEARING OUT. THANKS FOR THE VIDEO.

  • @kossllan6144
    @kossllan6144 Рік тому +1

    How much will co$t me, if dealership do it?