Carbs removal Yamaha XJ600 Diversion
Вставка
- Опубліковано 11 лют 2023
- Here it is, the much awaited follow up. We've removed the Divvy's tank and now the carbs. This video shows the whole process so hopefully you can learn form my mistakes!
Apologies for the glitchy flash during the intro and the couple of seconds of black at 01:09 Tried everything to get rid of it but my editing package hates me. - Авто та транспорт
Very good vid.👍👍
Thanks a lot
I expieriened the same Desaster with my XJ 900 58L 1985😂
Great content! Thanks
Epic rebuild
At 4;53 , there is no reason to loosen those lower screws . My personal preference is to disconnect fuel hose only at the pump side end because the plastic T-connector at the carburetor is brittle ( it may be 30 yrs old ) . There has been metallic aftermarket T-connectors available .
Very nicely explained. For sure it cannot be done in just 1 hrs I think. At least for some that would do it for the first time. Got my like. Just to ask you... do you have a video about replacing the brake pads on the XJ? Thanks a lot. :)
Sadly not, Lots on here though. It's fairly straight forward.
@@motodevcam I see. Thanks anyway. :) .
Take pictures or just follow your films, will take them out tomorrow maybe. Was running poorly last year against the cold in October, started in Nov and Dec. Now not running anymore.
Im having a nightmare trying to fit my xj600 carbs back on. They keep popping off the rubbers.
Yeah, been there!! Trying to get them all in then one pops off etc. Try warming them up with a hair dryer to make them more pliable?
highly recommend getting new ones as old rubbers shrink and lose flexibility. Those rubbers between engine & carbs aren't expensive and can easily be bought. But the rubbers between airbox and carbs are a completely different story. Those rubbers came in two versions with different diameters. And you can buy only used ones. I didn't realized that until I've disassembled my seca II and couldn't get airbox back on the carbs so have to buy entire used airbox with a set of 4 bigger diameter rubbers. Sometimes ppl don't realize that and try to put smaller rubbers on bigger connectors without success.
Same yahamahaha here, quite rust in the tank, need to redo the fuel valve. Is the hexagonal thing a pump and are they serviceable? I am a bit afraid of the carburettors and my technical knowledge combined
The carbs are fairly easy. Keep them while (attached together) and it's just a case of loads of carb cleaner spray and ideally an airline to blow out any bits in the channels that you've loosened. Balancing is fairly simple too with just basic ability. Yeah, the hexagonal thing is a pump of sorts. It's a diaphragm that activates a valve basically when the pressure builds to suck through the fuel. Have you looked at the XJRider forum? An endless amount of information and How-to documents, most with photos.
@@motodevcam If somebody needs XJ information , better hurry up since XJrider is closing up in November .
@@ciao5066 oh no really??! It's my main source !!