How to install a garage door opener - XTrac (Centurion) - detailed
Вставка
- Опубліковано 21 лип 2018
- PLEASE NOTE, THE SAFETY ASPECTS OF THIS UNIT DO NOT MEET THE SPECIFICATIONS THAT ARE STATED IN THE MANUAL!
How to install a garage door opener - XTrac - step by step
This is a detailed DIY, every step is shown so you may "do this yourself"
Centurion XTrac
Thank you. I am going to install a switch, so your video is useful.
Mate! That fiddly stuff from around 51:30 is exactly what I needed. Nice one.
good job
I have the exactly model like you how I put Centre
How can I put the safety centre in the same Moto
my motor is only showing 5v to the battery. i bought new power supply for the motor. How do you replace the charge controller and power supply box ?
How do you add a sonoff wifi switch
Great stuff. Thank you. I need to replace the battery on my xtrac but I do not know where is located. Please help
On Top Beside The Motor (The Opener)
@@koenakoketso thank you, how do we go about opening the compartment?
How do you replace battery
Remote controls?
My double door will not open🤨 thanks for the information sir.
Plein at the back
You can add two
Can you show me the video putting the wire safety sensor on the same motor what you show
ua-cam.com/video/tstO9FlDMLY/v-deo.html
I have the exactly model light you how I can put the safety sensor
ua-cam.com/video/tstO9FlDMLY/v-deo.html
How do I activate the safety reverse? When the door hits something it stops and reverses automatically.
it doesn't work
Hi, have you installed a Centurion SD04 garage door opener?
no
@@ecologicaltime hi how do I manually open the garage with the xtrac - im stuck
Hi. Do you have any contact information it would be helpful?
How do can I replace the backup battery?
Please do a video on changing backup battery
My door keep opening automatically when closing the door. What could be the problem?
have you checked the following: 1. loosen the safety lever/unlock lever and then try open and close the door manually. if there is minimal resistance, then you have ascertained that the door is not stuck.
2. Check there is no obstruction on the downward cycle.
3. Are there safety beams? If yes, disable them and then check again.
4. Check the limit switch placement
5. Check the calibration cycles. I would manually perform the re calibration and see if it performs it.
Were are u plz
Did not watch the entire hour video, but I could not see how to install a remote to the motor?
If it is there, whereabout in the video will I find it?
The rest was useful, thanks.
WHERE DOES THE DRIVE UNIT GET POWER
it feeds through the track and chain