Ford Y Block Rear Main Seal Install

[@genetaylor7421]

Guy's Thank you so much for making this video. My Uncle James Uselton passed down his 1955 Thunderbird to my wife Danielle. This is the last repair item I need to get this Bird back on the road. He did purchase a lot of performance parts from your shop before his passing. I made a promise to him to finish what he started. Gene Taylor Austin, Texas

[@jondalrymple6171]

Thanks John, I have used the air method with a little soapy water drizzled down the out side,

[@33plyrod]

didn't have all that stuff when I built my y-blocks back in the 60's. Didn't have any leaks with
the rope seals either

[@chuckschreiber2365]

Great videos. Looking forward to some top end ones, especially ones comparing stock heads to the aluminum ones.

[@MichaelRHull-wy7wg]

Very informative video John&Geoff

[@Mike62501]

Thank you John for your knowledge!

[@davidtreichelpppj5304]

Hey that was good . Mine went from a gusher (old rope) to a few drops so I'mhappy. Maybe someday I'll try your method to seal completely...Thanks

[@jamestone265]

Tough under the car for sure. Adding a PCV System and running 1/2 quart low on oil has vastly improved the leak the Ford I bought. I do not if it’s a top seal or not.

[@nathanielnewsome9198]

How do you remove the upper rope seal out with out removing engine from tractor

[@EricLopez-b5v]

What air pressure should you lightly check for leaks?

[@robskaaden3792]

Where do you get the rear main seal rubber from?

[@merc-ni7hy]

ok...i like y blocks and f.e's...i hit the sub ...lets see more good stuff

[@vitorin70]

TOP VIDEO!

[@sufferedenuf]

Tuff to do with the motor in the car/truck. Hoping mine is just the pan gasket.

[@chrisjarvis4449]

were's Gary ?😵‍💫 of the winter garden 😆

[@omarmattozzi5434]

Excelent

[@HodgeHodge-v8t]

my bolts were so loose that i put a little blue lock tight on threads when installing the new one.