Dryer Repair - Replacing the Drum Support Roller Shaft (Whirlpool Part # W10359270)

www.partselect.... Click here for more information on this part, installation instructions and more.
This particular Drum Support Roller Shaft is specific to Whirlpool manufactured brands including Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Glenwood, and Caloric. To find a drum support roller shaft specific to your model, visit www.PartSelect.com.
If your dryer is having any of these symptoms, then replacing the drum support roller shaft could solve your appliance problem.
1) Loud rumbling noise while dryer drum is turning
PartSelect Part Number: PS3492562
Whirlpool Part Number: W10359270
Tools used for this repair/replacement:
1) Putty knife
2) Phillips Screw Driver
3) 5/16th Nut Driver
4) Small Flat Blade Screw Driver
5) Slip Joint Pilers
6) 9/16th Wrench or Socket & Ratchet set
Get model-specific repair help from PartSelect.com. Learn how to troubleshoot, diagnose and repair your appliance with user-generated installation instructions, hundreds of step-by-step repair videos, and our Instant Repairman. If you've got an appliance problem, we can help www.partselect....

[@digitalflightworks8751]

You can do the whole thing with just lifting top and removing 2 inner screws from front panel. Then remove 1 screw from bottom of heat shield to gain access to rear left wheel. Right wheel much easier. Ive done this to my POS whirlpool several times, you will get good at it..trust me.

[@Vortran]

There are TWO rollers. The RH roller is far more difficult. Would be nice if you showed how to get the vent duct off. Mine was taped on so I just left it on. For the gas dryer (mine) you can't just stick your hand through the front to do the LH roller. For the RH roller, I had to take the lint trap duct off. The whole thing took a lot longer than I had hoped.
Lastly, I was really wondering if anyone ever lubes these things are mods it to have an actual ball bearing? Whirlpool could have used a damn bearing and not broken the bank. They should be ashamed for using a bushing. Bushings SUCK.