Saturn Transmission Remove & Replace Part 2 of 3

Поділитися
Вставка
  • Опубліковано 12 лис 2011
  • Shawn Villalpando replaces a transmission in a saturn S-series.
    This video is by a DYI / beginner.

КОМЕНТАРІ • 28

  • @ianm3343
    @ianm3343 2 роки тому +2

    Do you have a transmission Jack? I just did this job. I supported the engine with my engine hoist from the passenger side, removed the engine Cradle completely, came in with a trans jack on the drivers side and lowered it down. My way looks like less swearing and potential to damage things.

  • @romelonathan1932
    @romelonathan1932 2 роки тому +1

    Looks like it can b removed from the top is that possible

  • @grizzliesgaming493
    @grizzliesgaming493 8 років тому +1

    You dont have to take out the flex plate, just unscrew the inspection cover and take out the bolts but you can leave that up there jammed in too.

  • @theonlyshawn
    @theonlyshawn  12 років тому +2

    Yes. I can remove and replace a manual in 3 hours, whereas, the auto takes about 5. The manual is much smaller and lighter, too..

  • @theonlyshawn
    @theonlyshawn  11 років тому +1

    It's essentially the same except for clutch removal and shifter cables. The manual is much easier because it is smaller and lighter.

  • @chrisrichards1424
    @chrisrichards1424 Рік тому

    Any idea how to just remove the trans cover to replace a shift solenoid?

  • @fabricancustoms
    @fabricancustoms 6 років тому

    "We're not going to mess with our connection to our steering wheel, cause that's a pain." Thank god! That would've made this seem difficult.

  • @Iseekoutthetruth
    @Iseekoutthetruth 12 років тому

    what kind of camera do you use? what set up do you have?

  • @Redbikemaster
    @Redbikemaster 11 років тому

    How much does the manual differ in removal procedure? I'm going to be reinforcing my diff pin this summer.

  • @agthrillson
    @agthrillson 9 років тому

    why did you unbolt the steering collum?

  • @Dude13450
    @Dude13450 11 років тому

    did these use hydraulic or cable clutches?

  • @fueledbymusic3
    @fueledbymusic3 9 років тому

    I guess some car's transmissions are more easier to remove than on other cars. 12:00, I had to remove the whole cross-member on my 01 civic. On a Nissan Max, I did not need to do anything to cross-members

  • @TerminatorSony
    @TerminatorSony 12 років тому

    is manual more easy to remove ?

  • @gladymirrivera3137
    @gladymirrivera3137 Рік тому

    Is that at Saturn 2008 vue xe or not

  • @theonlyshawn
    @theonlyshawn  11 років тому +2

    There's no need to disconnect the starter on the Saturn.

  • @PackardBelltoll
    @PackardBelltoll 10 років тому

    how come i see him turning it counter clockwise when he states clockwise turns??????????

  • @theonlyshawn
    @theonlyshawn  11 років тому

    Correct..only the drivers side. If you remove the pass side you'll need to support the engine better.

  • @chadgrossman6239
    @chadgrossman6239 9 років тому +1

    is this the same way to replace a transmission in a 2004 Saturn ion 3?

    • @theonlyshawn
      @theonlyshawn  9 років тому

      Chad Grossman
      I have no idea about the ion. That's a chevy and not a saturn as well!

  • @Michael72453
    @Michael72453 8 років тому

    Good video....I removed my 2001 TAAT as per your directions. Are u aware of any rebuilding videos/info about the same transmission?

    • @theonlyshawn
      @theonlyshawn  8 років тому

      +Michael Delehanty I don't know anything about rebuilding them. I've just swapped bad transmissions for good ones. You could try saturnfans.com/forums as those guys know everything about the S.

  • @brandonGCHACHU
    @brandonGCHACHU 2 роки тому

    The differential pin must be a common issue on these. My gfs car blew it just cruising at 45 mph.

  • @pamelatrentacosta8185
    @pamelatrentacosta8185 5 років тому

    i done this once before in 2012 and now i have to do it again on same car in 2019; $150 in parts to do it yourself instead of spending $1,000 for a mechanic to do it.

  • @omarG19100
    @omarG19100 12 років тому

    @theonlyshawn Great vids man. question i have a 98 saturn sl1 and recently had a tranny put in, but after they did the work i get a rattle when i go up a bump tht wasnt there before. almost sounds like the battery tray but when i shake it its very secure. Could the frame be loose? if so wht size socket do u need to tightn the bolts under the frame? Thanks much.

  • @MissAmazanda
    @MissAmazanda 9 років тому +4

    So basically you take the whole car apart to replace the transmission lol

  • @Redbikemaster
    @Redbikemaster 11 років тому

    Awesome. Thanks.
    saturnfans username: sallydriver