6:25 , "not that much of a difference" .... There is no rough approximation as to the sensitivity for overcharging or undercharging, ideally in terms of the standard unit of measurement, Grains? The instructions mention using the Powder Probe Tip according to caliber size, is there any idea on a definition of size differentiations i.e. is 357 Mag considered small or large? Thank you for producing a seemingly useful product for extreme situations and the single video on it. The lack of explanation or clarity, especially for a U.S. designed product, is underwhelming, even if the explanation is unknown, which would be helpful clarity and transparency so users are left guessing,
I have followed the instructions to the letter and “no joy”. I have turned the die slowly all the way until it touched the shell plate and the insert protruded up about 1/4 inch above the die. Battery is good and installed properly. I have made many many attempts. I have spent early 3 days trying to set it up. Back it goes to the dealer
@@celestinethompson1659 is the Audible alarm going off at all? The insert should activate one micro switch when a case is present and the other switch should be activated by the powder level. I'd encourage you to reach out to the Mark 7 tech support department so we can assist with troubleshooting or replacement.
Thanks. I have not figured this out yet. This will be very helpful.
Do you have to clear the alarm?
6:25 , "not that much of a difference" .... There is no rough approximation as to the sensitivity for overcharging or undercharging, ideally in terms of the standard unit of measurement, Grains?
The instructions mention using the Powder Probe Tip according to caliber size, is there any idea on a definition of size differentiations i.e. is 357 Mag considered small or large?
Thank you for producing a seemingly useful product for extreme situations and the single video on it. The lack of explanation or clarity, especially for a U.S. designed product, is underwhelming, even if the explanation is unknown, which would be helpful clarity and transparency so users are left guessing,
I have followed the instructions to the letter and “no joy”. I have turned the die slowly all the way until it touched the shell plate and the insert protruded up about 1/4 inch above the die. Battery is good and installed properly. I have made many many attempts. I have spent early 3 days trying to set it up. Back it goes to the dealer
@@celestinethompson1659 is the Audible alarm going off at all? The insert should activate one micro switch when a case is present and the other switch should be activated by the powder level. I'd encourage you to reach out to the Mark 7 tech support department so we can assist with troubleshooting or replacement.