For part 1 setting up your toolhead on your Revolution be sure to check out: • Revolution Toolhead Se... For more information head over to our website! www.markvii-lo...
Yeah it sounds like coronavirus is slowing everyone down. A lot of states have a limited number of workers per building that are allowed. Putting most people building things instead of answering phones I'm guessing. Really good-looking equipment, would love to see some regular UA-cam channels do reviews on this reloading press, besides the obvious fella everyone seems to use. Echo
Hello, I have a question about the shell plate indexing, after adjusting and calibrating after a few hundred rounds the shell plate goes back to skipping or better said, not indexing correctly and I have to continuously re adjust the indexing screw. Why is this happening?
Hi Tom when the video Primers Xpress set up?
Yeah it sounds like coronavirus is slowing everyone down. A lot of states have a limited number of workers per building that are allowed. Putting most people building things instead of answering phones I'm guessing. Really good-looking equipment, would love to see some regular UA-cam channels do reviews on this reloading press, besides the obvious fella everyone seems to use. Echo
Hello, I have a question about the shell plate indexing, after adjusting and calibrating after a few hundred rounds the shell plate goes back to skipping or better said, not indexing correctly and I have to continuously re adjust the indexing screw. Why is this happening?
You may want to take the pall adjustment screw out and apply Vibratite. Also make sure the shell plate is not too tight ...
You never show how to install the springs in the Primer Orientation Sensor
they drop in below the sensor, the big one is furthest back.
Where’s powder check??