Case 580ck Moving trees and digging holes for a barn build
Вставка
- Опубліковано 17 лис 2024
- digging out trees, clearing woods and making room for a barn all while coming up with more materials to build with.
ww had a couple hiccups allong the way but we managed to get them sorted out pretty easily
#caseih
#building
#case580
#backhoe
#landclearing
I enjoyed seeing your tractor and hearing the purring of the engine, it makes me want to get mine going. Do you know if the engine has to come out to get the fuel tank out on the 580ck diesel? Mine was sitting, fuel turned to bio mass(brown crap) and have a small pin hole I need to fix. Where did you get those nice gauges from on your dash?
These old machines are addictive.
As for removing the fuel tank either pull the valve cover or head its self and pull the fuel tank that way.
Or pull the rod/shaft between loader arms, nut on either side and use a porta power to spread the two arms apart a few inches and remove the tube. Then you can lift the tank up
You can also pull the steering column and pull it out that way.
As for the gauges I ordered them off eBay for the full set and ordered the clutch pressure gauge separate from a different website
Hello. I have a 1965 John Deere backhoe that looks like yours. I noticed that you were messing around with the hoe while you were driving around because it is drifting, on mine there is a load chain hook welded to the boom and I can run a chain with a hook on each outrigger and then it hooks onto the boom to hold the boom centered while you are driving around.
I was moving it around to move my center of gravity, putting more weight on the rear tires or, moving it to get around obstacles
Seals are pretty good actually and it doesn’t drift, even left overnight
Ok, but with me, the lever does not stop, and the brakes do not stop as before. I do not know if they have anything in common, I would be grateful for advice on where to look for the problem.
Brakes on these old case tractors and backhoes were definitely less than ideal. Much room for improvement from the engineers.
What lever is in question?
Greetings for the clips from Bulgaria. Hello, I have an excavator like yours, with the engine running, I can't turn on the speed. The pressure is the same as yours, when I work, the gears heat up a lot, is this normal?
You have to have the shuttle in neutral and at a complete stop in order to change gears.
You should get a normal operating temperature, most equipment is usually 100 degrees Fahrenheit above ambient temperatures