A vented bolt , cut a notch across the hex with a grinder like a screwdriver slot and run a pc. Of wire thru the vent hole and bend a L in the wire at the end and use that to fish the bolt thru the pick up tube hole and bolt hole in the oil pump. Turn the wire with vice grips to start the bolt, tighten. Remove the wire
My favorite trick is the braided line but you can pre wind it up so when its close you pull slowly and it screws itself in a little way as the string unwinds from the screw
My innova 2007 is given backcompressure but no oil conjumption and no power loss.. Only some knocking on idle .. On acceleration no knocking...Pls reply...
@@ssman9925 all you need do is replace that oil ring and besides that should be good idont see why it would be an issue getting that bolt out of the pick up tube is a challenge
This man just threw us a lifesaver!!!
Yes sir 👍🏾🫡
Thank You for the pickup tube bolt hack. That would make that job easier. 👍
A vented bolt , cut a notch across the hex with a grinder like a screwdriver slot and run a pc. Of wire thru the vent hole and bend a L in the wire at the end and use that to fish the bolt thru the pick up tube hole and bolt hole in the oil pump. Turn the wire with vice grips to start the bolt, tighten. Remove the wire
And thats Real 💯 when you figure it out mechanically you know you have been doing it a long time ✊️
Thanks my brother
so nice and clean in there! Thanks for sharing the tip.
Thank you for watching
Thanks for sharing.
Hey man on march 29 on Friday I did it exactly how you did it with the zip tie an it worked perfectly I installed my new oil pump
I just have one question the new oil pump already comes wit a spring installed on the new pump right is that I didn’t check inside
Bro this might be genius
My favorite trick is the braided line but you can pre wind it up so when its close you pull slowly and it screws itself in a little way as the string unwinds from the screw
Nice.
Good thinking fella
“Man of genius !”
Pretty slick dude
Thanks bro 👍🏾
Yessir Ima need to do this on my Buddy Impala! Thanks for sharing 🔥🔥🔥
Anytime bro look me up on Facebook so you can get my phone number
@@ssman9925 What’s your name of Facebook?
Marcell Nicholas
Your oil pump pickup screen looks half plugged, did you leave it like that or drop the oil pan?
You can modify the hold down tab to change clock position. Done it that way since 2010.
Yeah that’s what i did it’s in the front not the back i was just showing if someone wanted to try it.
Are you talking about the hold down tab on the zip tie, if so how so?
When you use the zip tie make sure it’s a small one 👍🏾
On "some" pick up tubes, not all
My innova 2007 is given backcompressure but no oil conjumption and no power loss.. Only some knocking on idle .. On acceleration no knocking...Pls reply...
Thank you
But what if oil pan is leaking, wouldnt you want to just tackle both
The oil pan not leaking i was just taking the pump off with out dropping the pan.
@@ssman9925 all you need do is replace that oil ring and besides that should be good idont see why it would be an issue getting that bolt out of the pick up tube is a challenge
Which way do I turn the boat or not on the Hallmark balancer to get
What are you trying to do bro
So, where duz snippin' the back off go 2zzz anyways?
I never remove oil pan.