tonight i struggle a bit at this step with the washer on the side with the 2 bearings. the repair instructions from my service manual said that the short rod comes in the front hole seen from exaust side. but your right!! you know it better. thanks man
How hard did you fastend the screw that 8mm that holds the rod that comes from the engine and turns the PV? I did screw it pretty good, but then it would move so good as it should. Just afraid of tightening to loose, or too tight.
My understanding is, yes, although I've never had that problem with my bike. I would take the pipe offand look inside the front of the cylinder and see if the power valve is opening with the throttle opening. Otherwise ignition, and I usually start on one end and work my way through the bike. Clean air filter, check Reed valves, clean all Jets, check compression, check power valve, clean pipe and repack muffler as needed. If it's not your power valve, ask this question on gas gas Rider.org.
hello out there in gas gas land i have a 2004 ec 300 that i pick up. I am looking for a service manual? if any one knows of where to get one that would be awesome! i am in need of wiring diagram as well?
Justin Wyatt if you just Google gasgas manuals the first hit will take you to the gasgas Spanish English page of manuals, there are several pages of them so you will need to go back a few years to find the manual that you need. Be sure to subscribe to gasgas Rider. Org as well there is a plethora of great information on there
tonight i struggle a bit at this step with the washer on the side with the 2 bearings. the repair instructions from my service manual said that the short rod comes in the front hole seen from exaust side. but your right!! you know it better. thanks man
well done thanks
where can i get parts for a gasgas i cant get anything, its a 400cc the valve dropped damaged the head and crank
How hard did you fastend the screw that 8mm that holds the rod that comes from the engine and turns the PV? I did screw it pretty good, but then it would move so good as it should. Just afraid of tightening to loose, or too tight.
Nice, very informative :-)
I have a 04 ec 300. Its bogging down when it should open up. Jets are fine. Could this be a power valve issue where its not opening?
My understanding is, yes, although I've never had that problem with my bike. I would take the pipe offand look inside the front of the cylinder and see if the power valve is opening with the throttle opening. Otherwise ignition, and I usually start on one end and work my way through the bike. Clean air filter, check Reed valves, clean all Jets, check compression, check power valve, clean pipe and repack muffler as needed. If it's not your power valve, ask this question on gas gas Rider.org.
hello out there in gas gas land i have a 2004 ec 300 that i pick up. I am looking for a service manual? if any one knows of where to get one that would be awesome! i am in need of wiring diagram as well?
Justin Wyatt if you just Google gasgas manuals the first hit will take you to the gasgas Spanish English page of manuals, there are several pages of them so you will need to go back a few years to find the manual that you need. Be sure to subscribe to gasgas Rider. Org as well there is a plethora of great information on there