Home repair Frigidaire Electrolux Affinity dryer replace circuit board by froggy
Вставка
- Опубліковано 25 тра 2021
- Home repair Electrolux Affinity dryer replace circuit board by froggy
Thanks for over 12 million views and 20 thousand subscribers on my channel!
Attempt all work at your own risk. The publisher bears no responsibility for improper or unsafe repairs, injury, or damages to property that may result from your work or this video. As an Amazon Associate I earn from qualifying purchases. - Навчання та стиль
#ad amzn.to/3yP7YSr
#ad amzn.to/3foiJmX
#ad amzn.to/3i1y5zz
Thank you sir your video was very helpful with troubleshooting the issue with my dryer, which is the same make and model. I bought the replacement circuit board, swapped it out, and the dryer is working great.
The display showing dots moving around in a rectangular loop might come if you have a wrinkle release button and you have pressed it, or it could automatically enter into an anti-wrinkle mode when the cycled is finished. The drum will turn but the heat will be turned off.
Thanks!
Is it normal for the timer switch know to be a little hard like stronger than the one of the washer when turning it???
Should not be much difference, a little maybe
:)
I guess you are removing the lint from it often, but are you checking the following regularly:
'While the key is the heated air, but it has to be able to circulate and part of the circulation process is allowing the air to be removed from the drum.
If the air is not able to escape readily it will impede the proper drying time of the clothes in the drum.
There are a couple of things that can cause this reduction in the proper airflow and each one of them will need to be checked.
It is imperative that there is no obstruction of the vent opening that exits the house.
Be sure that little flap is not obstructed and it allowed to open and close easily.
The other thing you want to check is the ducting the runs from the outlet of the dryer to the vent opening in the wall.
If you find any problems with the ducting such as; partial collapsing of any part of the ducting or you find any holes that have developed anywhere along the length of ducting.
You want to immediately replace the ducting with a brand new piece of ducting if it is damaged.
Also, if there is a problem with the vent flap you want to address that as soon as possible.'
So far I haven't been able to find out what is causing the timer to not function properly. Use another timer so things does not catch on fire, just in case.
Thanks for a long reply, it def. was the circuit board. :)
Maybe you just didn't push the timer display connector properly in there? Or you didn't connect it properly to the screws at the other end of it? And the circuit board must also be connected to those screws in some way, I guess.
It works perfectly just the spinner display seems new?