Hello...I just put my hands on this controller but the Ethernet leds are not blinking. I'm feeding with 24V and plugged it in the Router. I was expecting some activities in the Ethernet port, even with all other Pins disconnected. The Router says no device is plugged. What am I doing wrong ?
I need help with this Nvem v2 controller, always I have to reset mach3 to run ref all home, and sometimes when running a gcode the machine stops suddenly or shaking with loud noise that must be restarted , please , have you some tips for it? my power supply used on this controller is 12v, a think to change the power supply to a 24v , I think the controller need to sink extra energy to run fine.
Hello, is it necessary to use the RS 232 cable for the safety of the CNC machine to work with the Mach3 program or is it only used to show the values? Please help and thank you very much
hello, which power supply will you suggest to run 4 of these drivers? will it be enough 2 x 48v 10amp units (each one will control a pair of steppers)?
when conect with router to control by WIFI check that the router assigns ip 192.168.1.X being X is 2-199 otherwise it will not work . Cuando conecten al router para controlarlo inalambricamente asegurense que el router asigne ip 192.168.1.X donde X es valor entre 2-199 de otra manera no lo veran conectarse al mach3 de manera inalambrica(wifi)
Hello...I just put my hands on this controller but the Ethernet leds are not blinking.
I'm feeding with 24V and plugged it in the Router.
I was expecting some activities in the Ethernet port, even with all other Pins disconnected.
The Router says no device is plugged.
What am I doing wrong ?
very helpful, thanks!
Hi sir can you help me with that NVEM i have a problem with connecting
I need help with this Nvem v2 controller, always I have to reset mach3 to run ref all home, and sometimes when running a gcode the machine stops suddenly or shaking with loud noise that must be restarted , please , have you some tips for it? my power supply used on this controller is 12v, a think to change the power supply to a 24v , I think the controller need to sink extra energy to run fine.
Hello, is it necessary to use the RS 232 cable for the safety of the CNC machine to work with the Mach3 program or is it only used to show the values? Please help and thank you very much
Hello, I'm manufacturing my router as a hobby, but I want an electronics with nema 34 motor close loop ... Did you like this configuration set?
hello, which power supply will you suggest to run 4 of these drivers? will it be enough 2 x 48v 10amp units (each one will control a pair of steppers)?
Essa controladora tem entrada para encoder
Hello !!!
Please show how to connect and control PWM
Thank you
Any idea for rs port connection. . I had the same unit but can't figure it out the connection over rs
when conect with router to control by WIFI check that the router assigns ip 192.168.1.X being X is 2-199 otherwise it will not work .
Cuando conecten al router para controlarlo inalambricamente asegurense que el router asigne ip 192.168.1.X donde X es valor entre 2-199 de otra manera no lo veran conectarse al mach3 de manera inalambrica(wifi)
У вас есть драйверы для этого контроллера??? Можно у вас его получить на почту @
нашёл? я скачал в свободном доступе в интернете....
Здравствуйте. У вас плата работает исправна на вашем драйвере / плагине dll
Blir bra sugen på gå över till dessa motorer själv
LOL, nothing like having to learn mandarin colors because they wont print out a piece of paper for instructions.