Ben's Builds: LS Rod Bearing Install and Measuring!
Вставка
- Опубліковано 29 вер 2024
- Ben installs and measures his rod bearings for his LS build!
Facebook page: / brokeassmotorsportsohio
Instagram page: / brokeassmotorsportsohio
Where's My 10mm Podcast Facebook: / wheres-my-10mm-podcast...
Group Members Instagram Pages:
Ahoff: / therealahoff
Josh: / projectomega.c5
Jake: / kaboosted_st1320
Bryan: / foreshadowthegalaxie
Ben: / benrodriguez2013
Podcast Instagram: / 10mmpodcast
Podcast Site: www.buzzsprout...
So I don’t know, I’m watching you measure the bearing with the bore gauge and that’s great but I grew up putting mopars and chevys together and I was always of the understanding that you tighten the bearings in the rod once and never twice. We would measure clearance by deflecting the rod or tilting it and getting an angle to let us mathematically figure the assembled clearance. If you tighten the bearing in twice you could cause it to be spun later. I have also built engine using the double bearing set method, crush the first new set and then measure, discard and then put in the second set for race, no spun bearings this way. Of course your way may be just fine too.