Ben's Builds: LS Crankshaft Install Using ARP Studs!

Ben continues to build his LS Engine by installing the crankshaft! Check him out on TikTok: www.tiktok.com/t/ZTRE5GNn7/
Facebook page: / brokeassmotorsportsohio
Instagram page: / brokeassmotorsportsohio
Where's My 10mm Podcast Facebook: / wheres-my-10mm-podcast...
Group Members Instagram Pages:
Ahoff: / therealahoff
Josh: / projectomega.c5
Jake: / kaboosted_st1320
Bryan: / foreshadowthegalaxie
Ben: / benrodriguez2013
Podcast Instagram: / 10mmpodcast
Podcast Site: www.buzzsprout.com/2029319

[@stevenbelue5496]

I didn't see the thrust get set and there was no mention of the most vital part when going to studs, maybe the machine shop checked, align honed and set the clearances. If so I would throw a mention in the video to educate others, when going to studs from bolts it distorts the main bores enough to throw clearances out of spec. Good luck with the build/car, the performance world is a huge addiction.

[@GrandPitoVic]

I love that blue!!!

[@albertlevy8818]

That’s a decent amount of assembly lube if you’re running .250 clearance on the mains. If you were running .0025-.0035, all that lube squeezed out of the sides.

[@GrandPitoVic]

Great conversation brother. Even tho it was one sided. I enjoyed it lol..

[@Airman..]

Have you checked main cap bearing clearance before installation?

[@GrandPitoVic]

Hey brother, is this block painted Ford Corporate Blue? I like that color.

[@westcoast6162]

3:48