Love the simplicity of it, that's what I need and want, May try to replicate this, thanks for sharing. Like the fold up, you can still use back seats, I have a 2009 Jku. Good job.
Ild cut off about 1/2 inch on the depth if you have a drop down tail gate table like I have now… other then that, I just added a 1/4 inch spacer and bottom piece of wood to help the drawers not pinch when I have hundreds of pounds on top of it. If did it again I would scrap the door hinges and put L brackets on the front of a free floating piece of plywood that could just slide straight back and go into a plunge cut at the back of the drawers.Good luck🤙
Hello, thanks for this informative video! It’s amazing setup that I might do. Can you provide any update to the video or anything you would adjust after having this setup for over a year?
The only thing I changed so far was putting a piece of plywood underneath to allow the drawers to pull out when I have hundreds of pounds of gear on top of that. I added about a quarter inch spacer all the way around to give the drawers a little more clearance.
Thank you! I have been searching for a video just like this for the last 6 months!
Love the simplicity of it, that's what I need and want, May try to replicate this, thanks for sharing. Like the fold up, you can still use back seats, I have a 2009 Jku. Good job.
Too bad it was cut short, very informative. I might used this as my setup. Can't now since I will be heading to Zion Nat. Park on Saturday. Thank you!
Great build. Have something similar but a bit different. Really like your setup though.
Not a bad rough draft.
good clean design. you could cut the front piece 40/60, so you could have the 40 seat up and still room to sleep inside if you have to.
Good point.. gotta love the room of a 4 dr. I have my 2 dr JK so I can drive with the single bed made up.. my pass seat folds flat.
Nice work!
Could you possibly talk about the L brackets you mentioned at the end? Thanks for the video. It’s the best most simplistic video I’ve seen so far.
Updated slide out top vrs original flip
ua-cam.com/users/shortsY_IGobs3cvo?si=T0vk3iPgMeqbAZdI
Just did a super quick one for you as I can’t put the seats down at the moment due to lumbar.
Nice build thanks for the video going to try and replicate!
Ild cut off about 1/2 inch on the depth if you have a drop down tail gate table like I have now… other then that, I just added a 1/4 inch spacer and bottom piece of wood to help the drawers not pinch when I have hundreds of pounds on top of it. If did it again I would scrap the door hinges and put L brackets on the front of a free floating piece of plywood that could just slide straight back and go into a plunge cut at the back of the drawers.Good luck🤙
Hello, thanks for this informative video! It’s amazing setup that I might do. Can you provide any update to the video or anything you would adjust after having this setup for over a year?
The only thing I changed so far was putting a piece of plywood underneath to allow the drawers to pull out when I have hundreds of pounds of gear on top of that. I added about a quarter inch spacer all the way around to give the drawers a little more clearance.
I just added another change to the recent guy that asked:)