how to replace the front shock absorber on a 2016 Vauxhall / Opel Corsa (mobile mechanic)

Поділитися
Вставка
  • Опубліковано 30 вер 2024
  • the seals I'n this shock had deteriorated allowing fluid to leak leaving the customer not enjoying her ride. so I replaced it for her.
    so you can do this all with basic hand tools apart from the spring compressors this set only cost me something like £20
    you'll need
    ▪ Jack and axle stands
    ▪ powerbar, locking wheelnut tool and 19mm
    ▪ 17mm, 18mm and 8mm spanners and
    ▪ spring compressor
    this job even though basic is very dangerous. if that spring comes loose and hits you, you could literally die so please be careful!
    this is just a video on how I carry out this repair and if copied it is done so at your own risk I am not responsible for any damage or injury cause by following these steps

КОМЕНТАРІ • 17

  • @stevelake9333
    @stevelake9333 2 місяці тому +1

    Apart from the weather shield removal , is this the same process on a 2015 facelift insignia, to remove the coil ? Cheers

    • @EllsAutoCare
      @EllsAutoCare  2 місяці тому

      @@stevelake9333 I honestly don’t know

    • @stevelake9333
      @stevelake9333 2 місяці тому

      @@EllsAutoCare ok, thanks anyway 👍

  • @astrumspace
    @astrumspace 5 років тому +1

    I love the warning in the description 😂

  • @DeadHeartzLollipop
    @DeadHeartzLollipop 5 місяців тому +1

    What do you have the car jacked up on while you are doing the work, is it on an axel stand?

  • @meirionevans9088
    @meirionevans9088 3 місяці тому +1

    This is nuts scrolling through youbtube this popped up donthis today 😂😂😂

  • @interestingspagetti
    @interestingspagetti 4 роки тому +2

    Hey. Thanks for the video. Just going to do my combo van. Long time since i did my own work, but needs must. Great vid.But first, i will need to see that i still have all the spanners and sockets. My son was always in my tool box fixing his BMX and nothing ever went back.

  • @sarperriza5550
    @sarperriza5550 Рік тому +1

    You haven’t fitted the bump stop and dust boot

  • @alexbell6527
    @alexbell6527 3 роки тому +1

    Good video, but do get some ratchet spanners. Be a lot easier when doing top nut back up.

    • @EllsAutoCare
      @EllsAutoCare  3 роки тому +1

      Iv got them mate. But your wont get a ratchet spanner in there the holes to narrow. Youll need a tidy off set spanner