Quick rear dash cam fitting hints & tips

Поділитися
Вставка
  • Опубліковано 28 вер 2024
  • Short tips video showing how to install a rear camera with the minimum off trouble.

КОМЕНТАРІ • 17

  • @jacobvarughese4436
    @jacobvarughese4436 11 місяців тому +3

    This was the best advice I found. Long skinny screw driver and wd40. Fished it through is less than 60 seconds. Thank you so much!

  • @samal3196
    @samal3196 2 роки тому +11

    Legend man. Just been fitting a dashcam myself, and you and people like you have been a massive help to me. Very much appreciated, and I'm sure other folks agree!

  • @XelaTar
    @XelaTar 7 місяців тому

    Bună, un videoclip pentru Ford Fiesta 2008? vă rog, și cum știu dacă mașina mea are un sistem de monitorizare inversă încorporat? Am o cameră auto de la Orskey DashCam 1080HD. Mulțumesc.

  • @duXieduX
    @duXieduX Рік тому

    Where would the power come from in the rear? I don't seem to have a rear 12v socket on my new model

    • @PJsprojects
      @PJsprojects  Рік тому

      On this install the rear cam had a interconnected wire to the front cam so pulled power from that.
      For a stand alone rear cam you run a cable to the cars internal fuse box.

    • @ashchoudhury
      @ashchoudhury 11 місяців тому

      Is this the rear of a VW Arteon?
      Struggling running wire from front to back. Using the tool, how easy is it to remove without breaking clip? I have a Blackvue cam. Any guidance be appreciated . Thanks

    • @PJsprojects
      @PJsprojects  11 місяців тому +1

      @@ashchoudhury Tbh being trade I did work on that many cars I don’t know the model of the one in the video.
      In a VW the rear rubber flex has a plastic inner where it clips in to the car body and the bootlid, these plastic inner sections have four plastic tabs that pop out behind the metal.
      To remove the. Carefully push a plastic lever tool down wash side of the rubber flew where it meats the metal. They are very flimsy and I’ve seen a lot of techs snap them only to then superglue the rubber end to the car….

    • @ashchoudhury
      @ashchoudhury 11 місяців тому

      @@PJsprojects thanks. I'll give it a go

  • @robertthomas1569
    @robertthomas1569 5 місяців тому

    use Vaseline to grease them wires up

    • @AM-mv6ro
      @AM-mv6ro 3 місяці тому

      Vaseline is petroleum based and it’s not good for wires or rubber!!

  • @timherman4712
    @timherman4712 2 місяці тому +1

    Thank you, was at the finish line struggling and this video got me there! Update: thought I was done until I realized I ran the wire on the wrong side of the door trim gasket and then had to pull it out and do it again, but it was easier the second time lol thank you for the video!

  • @davidhargreaves1728
    @davidhargreaves1728 Рік тому

    Earth your rear camera then it won’t interfere.

  • @georgez.9818
    @georgez.9818 Рік тому +2

    Yellow cap WD40 is silicone based and safe to use with rubber
    It takes a little bit of research to use the right materials my friend

    • @PJsprojects
      @PJsprojects  Рік тому

      Oh I know about the different types lol.

  • @sheepforges1748
    @sheepforges1748 2 роки тому

    Hi, How would you recommend fitting a rear cam into a Corsa 2014 D, since it doesn't have the plastic trim at the top of the boot, its all metal. Any videos showing that? Thanks!

    • @parthivb696
      @parthivb696 7 місяців тому

      Same issue here - did you find any information on this?

    • @sheepforges1748
      @sheepforges1748 7 місяців тому

      @@parthivb696 Nope, I just went for a front dash cam only.