Civil 3D 2017 New Features - Corridor Baselines & Corner Cleanup

[@ugurgemici8696]

Chief Jeff is best teacher in the autodesk even in the world...

[@kiyagaedwin]

This is one of those features civil 3d should have introduced in 2012. Very time saving.

[@engineeredefficiencyinc.3116]

Feature lines as baseline for corridors is a welcome addition!

[@aurorasanchez7922]

Iam learning from you since you was with Lynda.

[@rajakhan-tx5nw]

As of 2024, this feature has not yet been implemented for daylight. Please guide me if I am mistaken. 3:02

[@kaackster]

Great information. what would be the workflow to finish the design? i.e. drain inlets, slopes and slope direction, etc.
thanks, love your videos. very informative.

[@fcamargo84]

I'm your fan, Jeff!
Thank you

[@nuwanin008]

Thank you

[@zagvot]

Really Great Video ...
Thanks for Uploading...

[@JeffBartelsCAD]

Thank you so much for your support!

[@hugofurtado5133]

Dear Jeff, the Corner Cleanup only works with corridor made from feature lines?
Thank you for your support!

[@SkeleTele]

Jeff, is there a way to make assemblies reference the alignment with an angle other than 90 degrees, can the assemblies be set to a giving angle? Thanks and great vids!

[@umaraliarshad7454]

Dear Jeff can you please make a video for beginners, in which you show each example on how to use transparent commands.. thanks alot

[@kaackster]

also, you mentioned that the feature lines were all 3d. did you grade them for slope? or they all the same elevation? is the surface one elevation (flat)? i'm just trying to figure out the procedure here. do you go back after the fact and raise/lower areas to create the slope in the parking area?

[@billyjoebob998]

Fail

[@nguyensinh1854]

THANK YOU .

[@handymumu5417]

sir how to make retaining wall?

[@merwinperez1748]

dear sir jeff how to calculate cut and fill volume for feature walkway including asphalt .thank u