Great review, thanks .... but please note that 0,12 seconds = 120 milliseconds, not 12 milliseconds. Using a frame rate of 25 frames, one frame lasts 0,04 seconds. Otherwise the frame rate would be 250 frames / sec
Great review about Vaxis Atom 500 & Hollland mars 400, It was clearly understood I love the way you explain thank you actually this will be very helpful, good luck in your next projects
I tested the Mars 400s on Canon RP with adapter and 50mm EF 1.8 stm using feiyutech 2000 gimbal. Mars 400s had the 550 battery. Mars was mounted upright on hotshoe. The gimbal had light vibrations only noticeable to the feel periodically. Battery on gimbal lasted about 9 hours from full to one bar. I had the gimbal stationary on my table and picked up approximately every 10mins and working the motors for around 3 mins at a time. I will likely make a video on my other channel sometime soon
I like both of them. Mars has better-built quality, Vaxis is not bad and lighter as well. Now Vaxis have a huge discount on the official website $299. Get also an extra 10% discount (coupon OMA10) bit.ly/2V38r0Q
Well I can tell you the Holyland is crap compared to the Atom. Put two Holylands side by side and you get crazy ghosting issues. The Atom doesnt ghost even when using 4 units side by side. The Atom goes way beyond 250m but the Holyland breaksup up once you past 150m. The Atom can run a whole day on a 20000mah Battery bank .... Which is awesum. In my country the Atom is half the price of the Holyland.... They choice is obvious
Thank you for sharing these information. Unfortunately didn't have the chance to test multiple units on the set. However, I did one test and did not included in the video. I get interference with atom and stop working when running Atom and Hollyland at the same time. My testing improved that Hollyland Mars 400 survived as Atom for 270 meters in line of sight. Personally if I had to pick one will go with Atom 500 mainly because of the good performance and lower price.
hello, good job thank you. One question, I just bought the 400s and when i turn them on in the Receiver I get this message. SISTEM EXCEPTION ERROR CODE 2. and it has no signal, is there isomething else that I have to do to make them work> thank you very much in advance
Man 0.12s are not 12 milliseconds, they are ten times more! 120 milliseconds! It is quite a lot, and unusable for focus pulling. There are products in this price range that do 2-3 times better (like Accsoon, but still difficult to use for focus pulling)
Thanks for watching Diego, Vaxis by the way have huge discount now on the official website $299. Use the link in the description for extra 5% discount as well.
@ However, Inkee Benbox can transmit a signal to laptop via WIFI (When I tested it I found Mac app does crash while Windows app is totally fine) Check the review here on the channel
You don't need a screen if the camera is running on 1080, while the camera screen turns black right after you hit record in 4k, you need an external monitor though.
Vaxis Atom 500
10% OFF (coupon OMA10) bit.ly/2V38r0Q
Amazon ➭ geni.us/vatom500 eBay ➭ ebay.to/3cRbIXZ
Hollyland Mars 400
Amazon ➭ geni.us/hmars400 eBay ➭ ebay.to/2Yp5No4
Promo Code doesn't work
@@djwarship2118 It's working now, please try again.
Thanks for highlighting this.
Great review, thanks .... but please note that 0,12 seconds = 120 milliseconds, not 12 milliseconds.
Using a frame rate of 25 frames, one frame lasts 0,04 seconds.
Otherwise the frame rate would be 250 frames / sec
Thanks you for highlighting this :D
Great review about Vaxis Atom 500 & Hollland mars 400, It was clearly understood I love the way you explain thank you actually this will be very helpful, good luck in your next projects
Glad it was helpful!
I tested the Mars 400s on Canon RP with adapter and 50mm EF 1.8 stm using feiyutech 2000 gimbal. Mars 400s had the 550 battery. Mars was mounted upright on hotshoe. The gimbal had light vibrations only noticeable to the feel periodically. Battery on gimbal lasted about 9 hours from full to one bar. I had the gimbal stationary on my table and picked up approximately every 10mins and working the motors for around 3 mins at a time. I will likely make a video on my other channel sometime soon
Regarding the delay, 0.12 sec = 120 milisecond, not 12 milisecond
My mistake 🙏
Amazing video bro. I learned a lot from the video. I really like the video. I hope everyone will find this video useful. Thank you.
Vaxis by the way have huge discount now on the official website $299.
Use the link in the description for extra 5% discount as well.
I just got the Vaxis but the app won't even load on my ipad! Works great on my iphone. Sending it back and switching to Hollyland.
Consider Mars 300 Pro. Love it
Great video.. But if u have to choose one, which would it be?
I like both of them. Mars has better-built quality, Vaxis is not bad and lighter as well.
Now Vaxis have a huge discount on the official website $299.
Get also an extra 10% discount (coupon OMA10) bit.ly/2V38r0Q
Politically correct answer.
I am impressed, a great review. You think these products can be used to focus at a distance. For example together with the tilta nucleos?
I dont have focus puller, I'm not sure about that. May you find some reference on the web.
Hi I'm trying to update the firmware X1.1.3 but without success, do you know how to do it?
Great tests. Thank you for sharing.
Well I can tell you the Holyland is crap compared to the Atom. Put two Holylands side by side and you get crazy ghosting issues. The Atom doesnt ghost even when using 4 units side by side. The Atom goes way beyond 250m but the Holyland breaksup up once you past 150m. The Atom can run a whole day on a 20000mah Battery bank .... Which is awesum. In my country the Atom is half the price of the Holyland.... They choice is obvious
Thank you for sharing these information. Unfortunately didn't have the chance to test multiple units on the set.
However, I did one test and did not included in the video. I get interference with atom and stop working when running Atom and Hollyland at the same time.
My testing improved that Hollyland Mars 400 survived as Atom for 270 meters in line of sight.
Personally if I had to pick one will go with Atom 500 mainly because of the good performance and lower price.
@@OmaGhomrawi Totally agree with you there, I also love the fact that there are no Antennas on the Atom.
Great video man!! 💯💯
Glad you enjoyed! Check the new Mars 300 Pro Standards as well. I have a review here on the channel
Great video! What happens when you turn off your camera between takes - do you have to go through the boot-up process each time?
it actually takes just few seconds to recognize the connection
thanks for reviewing this
Great video, keep it up!
Vaxis by the way has huge discount now on the official website $299.
Use the link in the description for extra 5% discount as well.
great video, good information. thanks for sharing
Glad you find it helpful. Best!
I want to buy Mars 400s pro or Vaxis Atom 500. What is better, please recommend me 🙏🏻🙏🏻
I do prefer the Mars 300 Pro
Check the review here: ua-cam.com/video/0Lg_XN1GatE/v-deo.html
hello, good job thank you. One question, I just bought the 400s and when i turn them on in the Receiver I get this message. SISTEM EXCEPTION ERROR CODE 2. and it has no signal, is there isomething else that I have to do to make them work> thank you very much in advance
Hi, Unfortunately I know nothing about this error. Better to get in touch with hollyland support
how can I do that and what do you mean by that?
Are they support audio transmission as well?
Yea both of them
Man 0.12s are not 12 milliseconds, they are ten times more! 120 milliseconds! It is quite a lot, and unusable for focus pulling. There are products in this price range that do 2-3 times better (like Accsoon, but still difficult to use for focus pulling)
Great review thanks!
Thanks for watching Diego, Vaxis by the way have huge discount now on the official website $299.
Use the link in the description for extra 5% discount as well.
Thanks Oma, good video content.
Glad you enjoyed it Alec :)
Is it possible to power those on v mount battery?
you need a dummy battery like this one geni.us/AnoQ
Great video!
Vaxis by the way have huge discount now on the official website $299.
Use the link in the description for extra 5% discount as well.
Can the vaxis be connected to a laptop?
Can transmit signal out from Laptop HDMI
@@OmaGhomrawi so it can't receive the signal from a camera to a laptop like the hollyland?
@ Hollyland Mars 400s /400 can not also transmit signal to laptop
@ However, Inkee Benbox can transmit a signal to laptop via WIFI (When I tested it I found Mac app does crash while Windows app is totally fine)
Check the review here on the channel
@@OmaGhomrawi Thank you Oma!
Very good video
Hey
Shit. Every single one… if you want something good get at least a teradek ace 500… at least that doesn’t have delay.
hola
Not very good.
.
Which one do you prefer? Honestly speaking?
I prefer Mars 300 Pro Standard. Check it out: ua-cam.com/video/0Lg_XN1GatE/v-deo.html
@@OmaGhomrawi Was the Enhanced version alot better? Or not much?
Enhanced version TX had external antenna, they should help more between obstacles.
Google it for more info
Do I need a screen or can I view from the camera screen?
You don't need a screen if the camera is running on 1080, while the camera screen turns black right after you hit record in 4k, you need an external monitor though.
@@OmaGhomrawi Do I have to hit record if its HDMI out to Atem mini pro?
Can I just put it on movie mode and be ok?
I don't know, I never heard of Atem mini pro
Very good video