I have all the information on changing security codes, deactivating motion detector, There are many videos on all of this from everyone imaginable. The one thing that I do not find is adjusting the sensitivity of the alarm on my 2015 Ultra Limited. No one seems to know how to do this. I know the older softballs you could do this. Is it possible to produce a video on this? I know if it can be done, I feel that you are the man to know. Thanks Doc, I always look forward your unlimited wealth of knowledge and appreciate all you do for all of us out here in the Harley community. Let me know if it possible, and how it is done. Thanks again.
Doc Harley, I have a small problem I have a 2006 Softail Deluxe, I am unable to find the pigtail to put in the alarm system for this bike. The side panel doesn't exist because that's the oil reservoir. It's Not underneath the battery. So I just don't know where else to look. If you could tell me where it's located I appreciate it
The H-D security system is installed by replacing the tour signal module (TSM) with the turn signal security module and then programed to your specific motorcycle. If you're trying to install the security system smart siren kit, the electrical panel can be found under the rear fender of the softail models. The rear of the vehicle can be raised slightly to allow removal of the splash guard. I can send you an image of the location if you email doc@lowcountryharley.com
Handlebar switch ON Switch OFF Both turn signal buttons at the same time. Odometer will message you that you are in transport mode and turn signals will flash 3 times. Thanks ~ Doc
Great tip doctor, I don't know if you've done a video on this but I was curious how soon can you start the bike when you turn the ignition switch? Should I wait ✋ till the fuel pump stops pressurizing? Or could I start it right away?
Battery condition, starter is of old style. HD has made a better- stronger unit. Are you following the owners manual procedure? You can’t abuse the reverse….Doc
Dear Doc, on my 2006 Electra Ultra I tried to get my PIN number via the typical on-off-on-off-on left turn 3x right turn 1x and NOTHING happens. Can you advise how to get to PIN.
The only way I know how to retrieve a PIN number is through a dealer digital Tech. Your sequence reminds me of the procedure to enter the pin for the first time. If you have the fob present this could install a new pin. Thanks ~ Doc
I thought you were going to just say that people where laughing as they saw someone trailering their Harley to a motorcycle event? People, you know you can ride them, right? Isn’t that why you bought the bike?
The owner's manual tells you how to replace the same bcm with no problem I'm just unaware and not sure if I replace the original stock BCM with the smart security BCM is there anything else to watch out for or is it a simple swap it out from one to another even though it's two different part numbers and the owner manuals doesn't specify on upgrading it to a smart security system
Not to mention the Siren going off all the time would get tiresome at best. Great video Doc. - keep em coming!
Morrin Doc-Harley u save somebody from a cold cup of coffe. 👍👍👍👍👍For you.and THANKS to 👉
LOW COUNTRY-DAVINSON.
OF Charlston,SC. YALL GET⭐⭐⭐⭐⭐ 👀👂👍
Best video by far. Straight to the point. Very helpful
Thank you...Doc
great clear explanation by a tech who knows how to speak explicitly! thanks Doc! more videos please Sir
Thanks Doc. Always look forward to your videos.
I have all the information on changing security codes, deactivating motion detector, There are many videos on all of this from everyone imaginable. The one thing that I do not find is adjusting the sensitivity of the alarm on my 2015 Ultra Limited. No one seems to know how to do this. I know the older softballs you could do this. Is it possible to produce a video on this? I know if it can be done, I feel that you are the man to know.
Thanks Doc, I always look forward your unlimited wealth of knowledge and appreciate all you do for all of us out here in the Harley community.
Let me know if it possible, and how it is done.
Thanks again.
When the system arms normally the indicators flash twice. When you disarm the motion detector they flash three times
Especially if you are going to trailer your bike to Baxter's Garage, handy little tidbit of information to have!
One of the Best places to go in the nation…Doc
How do I just eliminate the whole system?! 2011 fat Bob that drives me nuts!
GREAT, DO YOU HAVE A VIDEO SHOWING HOW TO REPLACE THE 9V BATTERY? MINE'S DEAD.. SORRY FOR CAPS LOCK
No I have not. Sure would be nice to know year and model….Doc
2001 FLSTF. Thanks Doc.
@@LowCountryHarleyDavidson
Doc Harley, I have a small problem I have a 2006 Softail Deluxe, I am unable to find the pigtail to put in the alarm system for this bike. The side panel doesn't exist because that's the oil reservoir. It's Not underneath the battery. So I just don't know where else to look. If you could tell me where it's located I appreciate it
The H-D security system is installed by replacing the tour signal module (TSM) with the turn signal security module and then programed to your specific motorcycle. If you're trying to install the security system smart siren kit, the electrical panel can be found under the rear fender of the softail models. The rear of the vehicle can be raised slightly to allow removal of the splash guard. I can send you an image of the location if you email doc@lowcountryharley.com
How do you do if we don't have a ignition switch? I have a 2018 heritage
Handlebar switch ON
Switch OFF
Both turn signal buttons at the same time.
Odometer will message you that you are in transport mode and turn signals will flash 3 times.
Thanks ~ Doc
Great tip doctor,
I don't know if you've done a video on this but I was curious how soon can you start the bike when you turn the ignition switch?
Should I wait ✋ till the fuel pump stops pressurizing? Or could I start it right away?
Yes I have a video on why to wait for the engine light to turn off before starting. Thanks ~ Doc
Great post. I've been wondering how to do this on my Road Glide.
love your videos please do more !!!
I have the red light, but it’s not blinking. It just stays on. Any suggestion
When was the last time you changed fob battery?
Hey doc Holly I got my reverse keeps going out on a 15 model that ain't got no miles on it and tell me why
Battery condition, starter is of old style. HD has made a better- stronger unit. Are you following the owners manual procedure? You can’t abuse the reverse….Doc
how can you disable it permanently ? It keeps killing my battery!
Doctor H, can you please help us with this Sir?
will the motion detector be reset to ON every time bike re-started and off?
Yes...Doc
Yes. It will
I didn't know that. Great tip. Thanks man
Dear Doc, on my 2006 Electra Ultra I tried to get my PIN number via the typical on-off-on-off-on left turn 3x right turn 1x and NOTHING happens. Can you advise how to get to PIN.
The only way I know how to retrieve a PIN number is through a dealer digital Tech. Your sequence reminds me of the procedure to enter the pin for the first time. If you have the fob present this could install a new pin. Thanks ~ Doc
You have to do it in a fast manner .it only gives you so much time to do it.. they don't say that..
Is it the same on an 08 doc
Great video!
Thanks…..Doc
Great tip, thanx Doc.
Hit BOTH turn signals or just the left?
Both
My Harley trike brake just stopped working
Off the subject, but do you ever adjust a hydraulic clutch?
no
Recovery van drove 850 miles back from the South of France without disabling this. Completely dead battery when it arrived.
Wanna try the roads in the UK 😆
Thanks.
Even reverse gear isn't working can someone help me
Without seeing it it’s hard to tell you what may be wrong, I’d suggest checking to see if your breaker was tripped.
Never knew that
I've seen a Harley Davidson dealership talk about how to disarm the alarm system are you kidding me are you kidding me
Not anyone can disarm just owners.....Doc
I thought you were going to just say that people where laughing as they saw someone trailering their Harley to a motorcycle event? People, you know you can ride them, right? Isn’t that why you bought the bike?
Lol you wanna talk about “bouncy roads”, come to Wisconsin. 😂😂😂😂
all this info is in the owners manual lol
The owner's manual tells you how to replace the same bcm with no problem I'm just unaware and not sure if I replace the original stock BCM with the smart security BCM is there anything else to watch out for or is it a simple swap it out from one to another even though it's two different part numbers and the owner manuals doesn't specify on upgrading it to a smart security system
RTFM? 😂