as soon as i touched that resistor it fell completely off, both pads were piss poorly flowed from the factory. resoldered both pads and mine lighted up... from the comments and votes, it almost feels like singapoor made that the intentional failure point to sell more units.
I cannot believe I missed this comment! Thank you for the feedback. The windows should be on a completely different circuit as the amp draw on motors is way more than the small incandescent bulbs.
that sounds more like a coincidence to me because like just jay said its on a different circuit. maybe you have a ground issues? ground issues can cause some weird electrical problems.
as soon as i touched that resistor it fell completely off, both pads were piss poorly flowed from the factory. resoldered both pads and mine lighted up... from the comments and votes, it almost feels like singapoor made that the intentional failure point to sell more units.
Thanks for the video. My soldering didn’t look good, but it worked!
You didn't show how it came apart
It is not complicated. Everything is held together with small screws, if I remember correctly. I did not need any special tools.
@@xfer43 I can’t find it anywhere on the internet or anywhere at that matter either.
@@canadiannonsensethere are about six silver screws that you’ll need to unscrew. Then it pops apart, pretty easy once you get going on it.
Thanks man, you are awesome. Worked for mine.
How does that console piece come out. I have the same issue and dont want to break it.
I am sorry… it was three years ago, and now I can’t remember.
Dude you rock! Thanks for the vid
Thank you!
HOW DO I REMOVE THE WHOLE ASSEMBLY ?? THANKS
I honestly do not remember when I pulled it. Sorry!
This did the trick! But Did you have any issue with no power to any of the windows after this? My current issue after fixing this
I cannot believe I missed this comment! Thank you for the feedback. The windows should be on a completely different circuit as the amp draw on motors is way more than the small
incandescent bulbs.
that sounds more like a coincidence to me because like just jay said its on a different circuit. maybe you have a ground issues? ground issues can cause some weird electrical problems.
Would be good if you had shown how to remove it
Sorry. I don’t remember it being difficult. I think it just pulls off.
Made in Singapore Lah!
HOW DO I REMOVE THE CONSOLE FROM THE CEILING?
Thanks for the video, my soldering didn’t look good but it worked!
Sorry for the delayed response. I really appreciate the feedback. It means a lot.