DIY Rear Projection Screen - Part 2 - Mic Stand Mounts!

Quick project/experiment to create a screen for home/hobby use.
This is quick, effective and cheap. If you had a slightly thicker 'curtain' material than I used then this would be incredibly good. You could probably make a decent front-projection in the same way.
Parts used:
1 x 'Frost' Shower Curtain
2 x 2mx32mm Push-Fit Waste Pipe
2 x 90deg 32mm push-fit corners
2 x t-piece 32mm push-fit joint
I considered using 40mm instead, for a larger screen that might be better, here 32mm is fine.
SORRY that the video is poor quality; marks on the camera, bad lighting and audio etc. I don't really plan to do these, I just make them while I'm doing things anyway :o)

[@officialjosefff9523]

Years later man and I just googled “hang projector screen using mic stands”. Only for once a year usage situation but rather helpful. Thanks for the video!

[@bakstagesi]

Hey thanks,
Sorry you had to watch the slowest video ever!
Would use hot glue if I did it again, the duct tape kinda came off when the weather warm.
Take it easy, s

[@1960tinotiger]

why you use a plastic that is almost clear