HERCUS 260 Imperial to Metric Change Gears. Part 2

Поділитися
Вставка
  • Опубліковано 12 лис 2024

КОМЕНТАРІ • 7

  • @D40..
    @D40.. Місяць тому +1

    Well that just looked painful but you got it done so all good, it's amazing what you can learn from doing jobs like that. Oh well till the next one

  • @RustyInventions-wz6ir
    @RustyInventions-wz6ir Місяць тому

    Very nice work sir

  • @NeverRest300
    @NeverRest300 Місяць тому

    What a legend!!! Nice work mate

  • @MyMiniHomeWorkshop
    @MyMiniHomeWorkshop Місяць тому

    It's always the seemingly simple jobs that turn into a pain in the arse. Publishing tip, watch the music in the background, I like to listen to the radio while I'm doing things and I've had UA-cam hit me with audible copyright music warnings for stuff you can barely hear and may only play for a couple of seconds, so now I turn it off before I record anything.

    • @NOideaMachining
      @NOideaMachining  Місяць тому +1

      Yeh they picked up on it mate… didn’t even think about it at the time.
      I’m amazed the cam picked it up so well.
      The phone was over the other side of the room! Oh well… I’m not gonna do it all again 😆😆
      Apparently it’s ok here in Oz, just might be muted in other countries.
      I’ll keep it in mind for the future. 👍

  • @davidharper4289
    @davidharper4289 Місяць тому

    Never ends. Haaahaaaa. Are you going to replace the bearings if you pull the main shaft? Anyway., Cheers, Davo

    • @NOideaMachining
      @NOideaMachining  Місяць тому

      Nah not this time mate. Bearings were fine anyway tbh.