Dichroic Extract with Berzerker - Glasscraft Webinar

This full webinar and others are available at www.glasscraftinc.com/glass-b...
Brian Serck, aka Berzerker, is known for his intricate and unique images in a brand-new medium, Dichroic Extract. During this 2-hour webinar, you'll learn about the break-through process that he uses to create his images. Dichroic Extract can be purchased from Glasscraft at www.glasscraftinc.com/dichroi...

[@pacifiedbeaumonte]

This guy has some of my fav pieces

[@tjscrubs]

Wow I just stumbled upon dichroic gold! Your a genius sir, thankyou so much for sharing, well taught in such plain and simple steps easy to follow. Will look into your classes, I'm from Minneapolis Mn. You deserve 10 times the subscribers, going to look through your other videos hoping to see how you scribe the images so well! Thankyou again.

[@TheFlowMagazine]

Thanks tjscrubs! If you ever want to learn the whole technique in detail, we have a recording of the live webinar available to purchase and stream at www.glasscraftinc.com/dichroic-extract-with-berzerker-a-recorded-webinar

[@MantisRay861]

thanks for sharing! I've been looking for new ways to use dichro!

[@dandamanman2200]

It's called trowelling cool vidio

[@glassblower209]

is the stincel just sandblasted?

[@dustinmiller1549]

Is it stable enough to work right in the flame and how easy is it to cover with clear in the flame of course

[@dustinregel4399]

Cool

[@oskarsstirna]

Hi! what if the glass is laser etched. Will this work?

[@ZebbMassiv]

So I can't find a video anywhere on how to properly attach a dichroic image and stretch it out into a pendant.Would be nice to know how to use these things

[@seagratz]

***** heat the glass side of your chip lightly by waving it in the flame and moving the heat around, all while heating a gather on the end of a proper sized rod. once you have enough glass gathered and its white hot, remove it from the flame to cool to orange hot or i tiny bit less. watch the dichro on your chip, once it crackles its about ready, remove your gather to cool at this point, keeping it centered, and allow the chip to slightly start to melt, like JUST barely, and the small chips 1/2 inch or 3/4 don't deform/melt them, less heat for those sizes. slap it down on the carbon dichro side up, and press your gather onto the dichro until it spreads over the chip. If you burn it at this point let your gather cool for a few more seconds, Then use a flared 6m rod to wipe the corners and make it round, using the edge of your flame. Once it's round, out in the tip of a decent flame start to melt it all together slowly, paddle the edge of your gather and chip, or L-marver it. dont stretch it, keep it the same size, most images dont like stretching, unless you have an image that will look good this way. Hope this helps you guys!

[@LordDice1]

What is in liquid stringer? I've used gum Arabic before, that works really well also. Btw, you spackle with a trowel. So I guess you'd call it troweling instead of spackling.☺

[@zdfsbnsdfn]

beautiful!! could u tell me about the stencils used? and do u heat it up in the kiln to melt the dicro into it?

[@DJae420]

Chantz temming Did you ever find out if you heat it up to get the image to stick?

[@f.j.b.]

are you located in nc?

[@zachhollinger9498]

scrape/spackle - Scraple