How to Troubleshoot a dead battery and find a parasitic drain

Поділитися
Вставка
  • Опубліковано 21 чер 2016
  • If your car's battery is dead after sitting for a few days, but the battery and alternator work fine, you probably have a parasitic drain. It's quite common to find these in glove box lights (like the one I found) or in any aftermarket audio equipment.
  • Авто та транспорт

КОМЕНТАРІ • 61

  • @radislost
    @radislost 2 роки тому +61

    *This battery reconditioning program exceeded my presumptions. It worked on any drill battery, several AA and AAA batteries, **batery.repair** and any camera battery. The steps are simple and the act itself is exciting to do. No matter what type of battery you`ve got, it is sure to function again!*

  • @jimfrank3249
    @jimfrank3249 Рік тому +2

    Excellent video. That is an great presentation. Clear and concise. Great way to troubleshoot the battery drain.

  • @ethanPi
    @ethanPi 2 роки тому +1

    Well done. This is the best video that I've seen on the issue. Much appreciated.

  • @4thdimensiontravels855
    @4thdimensiontravels855 Рік тому +2

    On a lot of BMW alternators if the diode is bad internally it will drain your battery. Even when the alternator is still charging . So check that too. Probably a video on that as well

  • @amana1480
    @amana1480 5 років тому +3

    Thanks for this video. My glove box light was staying on because the glove box had previously been broken into, which had bent the glove box door slightly, which prevented it pressing the switch to turn the light off....

  • @jkgrey3067
    @jkgrey3067 5 років тому +52

    Most of my parasitic drains have been blonde

  • @leadersuccess3761
    @leadersuccess3761 5 років тому

    Thanks a million for a very helpful video 🙂👩‍👩‍👦👍

  • @CAZTV
    @CAZTV 6 років тому

    2004 bmw 330 xi suddenly horn stopped working radio on off when visor lights pulled down air bag off.
    BMW said it Clock spring and ignition switch
    is that the likely problem One or both?. also a new airbag got installed about 1 year ago on the steering wheel .

  • @omarelsennary
    @omarelsennary 5 років тому +5

    You just saved my life and that of my car as well, i was planning to scrap it after draining my pocket!
    I can't seem to thank you enough, though!

    • @cacadeperro
      @cacadeperro 4 роки тому

      what was yours doing? mine started doing the same and now i cant even turn it on for 3 months. Im paying for it as it gathers dust.

  • @syednurnaim4800
    @syednurnaim4800 2 роки тому

    You are Very good education 👍

  • @hasan_chop86
    @hasan_chop86 4 роки тому +2

    Super helpful!

  • @elijohnson3475
    @elijohnson3475 6 років тому +1

    Great video bro! Liked & subbed!!

  • @przemek3028
    @przemek3028 Рік тому +1

    Dealing with same issue on my 325i have already checked the easy bits...fusses and alternator, the drain is 80 mA.Do I have to check relays now? And maybe final stage resistor on a climate control..??

  • @ryanwest4361
    @ryanwest4361 7 років тому +4

    do you still own your 328? Havent uploaded in a while is why I ask, btw I really enjoy your videos they have been incredibly entertaining and helpful!

  • @KatrinaDancer
    @KatrinaDancer 4 роки тому +1

    Many places can test your battery & alternator without u even having 2 take it out of the vehicle which is nice 😊

  • @brauchfaser8641
    @brauchfaser8641 6 років тому

    I have a 2008 E90 328Xi (Nav/HID/Htd Seats/Park Assist/Fully Loaded) and it needs the bigger more expensive battery $500.00 and the 180amp Bosch Alternator, except if you disconnect the battery you need to have it "PROGRAMMED" by BMW to re-connect / re-install it. HOW do I perform a parasitic draw test @ 10A without disconnecting my negative terminal?

    • @beetee801
      @beetee801 6 років тому

      Brauch Faser You'd have to measure current draw from the fuses rather than the battery.

  • @gsmecanica
    @gsmecanica 8 років тому +3

    Well explained, thanks mate. So in your case you replaced the glove box light or what was it finally?

    • @E36bmw
      @E36bmw  8 років тому +5

      Yep. Well, there was nothing wrong with the light, There's just a little plastic bit that is supposed to turn it off when the glove box is shut. Just needed to be put back into place.

    • @gsmecanica
      @gsmecanica 8 років тому

      good to know! thanks

  • @SirValeous
    @SirValeous Рік тому

    So what did your drain end up being?

  • @Mazel_Tov_888
    @Mazel_Tov_888 6 років тому +1

    Question: 328i battery drained down to 11vdc. I charged up to 12.5vdc. Left it over night not cold out in garage. This morning voltage is at 12.2 vdc. Is .3 vdc excessive drain for over night?

    • @4thdimensiontravels855
      @4thdimensiontravels855 Рік тому

      No, a battery will drop voltage after being charged, it's normal. In fact put the bolt meter on the battery as soon as you pull the charger and you can watch it drop, then level out.

  • @Scotford_Maconochie
    @Scotford_Maconochie 2 роки тому +1

    I'm currently battling a bad IBS and battery on an 2017 F15 X5 with 60k mi. The car died, was towed to dealership they found little to none, died again, boosted several times, died again. After an CEL came I scanned it and it gave me a code for a bad IBS. The car battery won't charge on a DEFA charger (the bad IBS fully depleted the battery 4 times or more). Will be replacing the battery and IBS in one motion, the register it, reset the DME and clear the codes. If this doesn't cut it then I have no idea what to do next...

    • @404notfound.....
      @404notfound..... 2 роки тому

      That's not a very difficult problem to find it all. I wouldn't be firing the "parts cannon" at it, that's going to get expensive very quickly. Find somebody with an amp meter that can determine how much Amps is being drawn, then put the vehicle to sleep and start measuring voltage drop across the top of the fuses until you find out which one is drawing excessive current, then get a wiring diagram see what's on that circuit and fix it.

  • @HawkEyesAndy
    @HawkEyesAndy 3 роки тому

    i have a bmw like that you're testing and it is driving me nuts, each time i check for current leaks with my multimeter it only reads 0.02 amps always, so i plug in the battery terminal and keep going normally, checking battery tension every once in a while measuring always 12,60 to 12,80 volts (full charge) suddenly in an hour it drops to 3 or 4 volts, having this issue for months

    • @mrlambo2972
      @mrlambo2972 3 роки тому

      Check alternator Voltage regulator and the wire going to it and make sure no rust built up and clean if possible

  • @colassolorzano6353
    @colassolorzano6353 4 роки тому

    I tried do this. But when I connect 1 end of the voltmeter to the negative side of battery pole. And the other end to the ground side from the chasis. Everything get power like im connecting the ground side to the battery

    • @aaratcliff
      @aaratcliff 3 роки тому +1

      yes, because you are completing the circuit with your meter. Just leave your meter connected and just wait for your car to go back to sleep.

  • @amana1480
    @amana1480 5 років тому +3

    7:12 You don't need to pull the fuses to check for a drain. Simply reconnect the battery then use the meter under the bonnet/hood. Connect the meter to ground (BMWs have a positive and negative terminal under the bonnet/hood too, eventhough the battery is in the boot/trunk) then the other side to the fuse (each fuse has a little hole in it to connect a tester without removing the fuse)

    • @jurikristjouw
      @jurikristjouw 4 роки тому

      Nice trick, but do I test on amps or volts then?

    • @jurikristjouw
      @jurikristjouw 4 роки тому

      ah never mind thanx tho for inspiring me, found an even better method: ua-cam.com/video/lRcj1fQcWwU/v-deo.html
      EXCEPT if you have a fuse with only one hole... please do share the magic

    • @cruzxd3776
      @cruzxd3776 Рік тому

      @@jurikristjouw MV

  • @SalikRafiq
    @SalikRafiq 4 роки тому +1

    on my 2001 E46 I have to wait 16 minutes for the car to go to sleep. When I did this I did see a draw of about 700mA. I pulled out a fuse and the draw went right down. I put the fuse back in to double check and the draw didn't go back up... Which is weird.
    Any idea if the CPU detects this and shuts that circuit down? seems odd really. My symptom is I fully charge up the battery, leave the car for three days and then drive it around for 2-3 days, the car will not start the following morning. Battery is dead. Not a clue...must be a short somewhere.

    • @404notfound.....
      @404notfound..... 2 роки тому

      Pulling fuses to determine a parasitic drain is not the proper way to do it on a late model vehicle, all you're going to do is wake up the modules again and you'll end up chasing ghosts.

  • @gilbertloza3383
    @gilbertloza3383 3 роки тому

    Do you still have the car ?

  • @trendntopik240
    @trendntopik240 Рік тому

    Mines was starter then I a dead cell changed I didn’t get it coded burnt my frm module replaced that now the damn car won’t start but I hear wrrrrrr 😅 and it’s killin me

  • @emelianenkofedor3478
    @emelianenkofedor3478 5 років тому +1

    Sounds like David Blaine

  • @amana1480
    @amana1480 5 років тому +5

    Don't you need to do something to put the car into "sleep mode" before testing it?

    • @almason253
      @almason253 4 роки тому

      I was thinking that as well.

  • @OsamaBinLlama
    @OsamaBinLlama 2 роки тому

    ac or dc?

  • @Icepressa
    @Icepressa Рік тому

    Funny cause You guys dont need to take any bulbs out…… simply just press in the door Locks the switches with turn the lights off without removing any bulbs asif the car is off, i Work out of my trunk all day long and do this to not drain the battery 👍

  • @beetee801
    @beetee801 6 років тому +2

    Went thru this headache. My problem was the lcm

    • @jurikristjouw
      @jurikristjouw 4 роки тому

      I feel your pain...i have replaced that part 3 times now LCM is a nightmare.

    • @Linoge279
      @Linoge279 3 роки тому

      how do you know its the lcm?

    • @beetee801
      @beetee801 3 роки тому +1

      @@Linoge279 after unplugging the lcm the voltage drain went away. So I just got a replacement and it fixed the problem.

  • @vincentbenavides6624
    @vincentbenavides6624 7 років тому

    I got my car diagnosed at o'rielys auto parts for all my error codes and most of them are electrical short circuits. do you think I'm better off buying the 100$ E46 repair manual to learn how to fix them? I have like 15 error codes and some are with the transmission. I have a 2000 323i sedan base model

  • @DjDestinyChicago
    @DjDestinyChicago 4 роки тому

    I’m currently dealing with this 👎

  • @aundraephifer9207
    @aundraephifer9207 2 роки тому

    De

  • @rsinghglobal
    @rsinghglobal 3 роки тому +1

    This test will not work if there are intelligent electronics installed on the newer BMWs.

  • @acescape88
    @acescape88 4 роки тому +1

    Thats not parasitic drain. You need to put your car in sleep mode. Do more research

  • @sethsmith6530
    @sethsmith6530 4 роки тому +1

    bmw's have a draw of .4 to .7 for 16 minutes until it goes to sleep. then you can perform a drain test. this video is a waste of time

  • @nicolemiller192
    @nicolemiller192 Рік тому

    Why are you talking so slow. Geez