K40 Test Fire Options Using Lightburn

After upgrading my K40 controller board only one thing was missing, the "test fire" function.
I show two ways to do this using Lightburn.
🔗 Please tell me if any of the links provided no longer work!!
🔗 Introduction : lasercutting.avataar120.com/e...
🛒 lasercutting.avataar120.com/e...
🛒 K40 40W Laser Engraving Machine s.click.aliexpress.com/e/_9Rxuc1
🛠 I buy most of my gear from either bit.ly/_Banggood_ or s.click.aliexpress.com/e/_APpCVa You can help me by using these links!
💲 If you would like to buy me a coffee: www.paypal.me/1nformatica
DISCLAIMER: Unless otherwise stated all products shown in this video have been purchased personally. The description and video may contain links to products which might be affiliate links, so if you click on one of the product links I could receive a small commission. This does not affect the price you pay. If you do purchase through my affiliate link this will help fund future videos, thank you for your support!
#CraftWorks

[@tymbarkoholik]

Im happy that You are happy for ESP upgrade but on slate by whisperer my pictures look better.... sorry mate

[@craftworks7232]

The quality of an image is not dependent on the type of controller or the software driving it. It is a product of the quality of the original image, the way it is processed and the preparation of the material used.

[@roccovalotta9490]

Depending on your power supply there is a spot to connect a test fire button. I will get a picture of my setup later today and share with you if you would like.

[@craftworks7232]

Thanks for sharing. Have a great day!!

[@cedricvivien8776]

That's true, however it fires the laser without setting the power. So you have a huge risk to fire at full power

[@craftworks7232]

@@cedricvivien8776 Great advice Cedric! I only use the macro in Lightburn.

[@squirralien1863]

Curious why you can't wire the momentary test button to the laser switch button, then rather than lock on lock off it will make the same contact with the momentary test and then your test button will work, ??

[@craftworks7232]

I guess that would work but my preferred solution is using the macro in Lightburn. Thanks for watching, have a great day!