You would probably need one of these battery door cover replacement parts which come with the adhesive pre installed. They don't seem to be selling the pre cut adhesive by itself for this phone. www.aliexpress.com/item/1005003697199471.html?spm=a2g0o.productlist.0.0.7f4a92e34vAp1s&algo_pvid=2d23a939-b038-4bc3-a40b-1eed95e27932&algo_exp_id=2d23a939-b038-4bc3-a40b-1eed95e27932-0&pdp_ext_f=%7B%22sku_id%22%3A%2212000026842857920%22%7D&pdp_pi=-1%3B31.31%3B-1%3B-1%40salePrice%3BUSD%3Bsearch-mainSearch
Wait there is actually a physical proximity sensor in poco f3 GT, then why it fail the proximity sensor test. Bc I did see other youtuber doing the proximity sensor test in mi x 5g & f3 gt and they said there isn't a physical proximity sensor. So what to believe now
I read somewhere that it is not the regular proximity sensor instead they used ultrasonic proximity sensor which is kinda new. Maybe it will get better after a few updates
I have a question sir. Do we have to remove the logic first whenever we do port replacement on this phone? I've seen a video where he does it. I asked but got no response. Hoping you can clarify this to me as I am trying to do it myself. Thank you.
Hi, you can always use a hair dryer if you are not sure since there is less of a risk of damaging anything. But you need to evenly heat up the back cover to the touch so when you touch it, its hot enough make it uncomfortable to leave your finger on it. You can always apply more heat as your working your way around prying it off. Also if you need to gain leverage to get your pry tool in between the back cover and frame, you can use a suction cup tool to help you lift up.
The top speaker of my k40g got crackles. Few first time i just knock it out or reset the phone then it work fine again. Now it crackles full time. Do you think replace speaker will help?
It's possible. Might be debris that got attracted from the speakers magnet to the speaker causing it to do that. You might be able to clean it off from the speaker filter once you remove the speaker.
Yeah, I'm not sure if they are push in or pull out ones. If its pull out ones, they should be able to be pulled out. If not, you need to take the phone apart and remove the rubber gasket in the frame, pull out the flex cable for the volume keys from the frame slot and push in the physical buttons into the frame to remove them.
My Phone MI POCO F3 working well Only During WHATSAPP VOICE MESSAGE and Recording, but not working in Normal Calls. i change the MIC sub board and strip also but dost not work. How to solve??
It's IP53 rated for water resistance. No phone is water proof, they are just water resistant. Enough water or pressure will cause the phone to get damaged.
Bro my device is poco f3 gt. My back panel and camera lens is cracked so would you help me to buy it can you give me the link to buy them plzz i have searched it for many shops 🥴
Here is a link: www.aliexpress.com/item/1005003249224927.html and on the same site, you can search poco f3 gt camera lens and you will see the camera lens part.
Very good video bro, meanwhile it would be awesome if you could take out the entire vapour chamber/cooling part by removing the screen, yes I'm well aware about the fact this will destroy the device. I'm searching for Jerryrigeverything2
Thanks. Ya at the moment if i were to destory the phones, i wouldn't be able to continue doing videos for very long since I would not be able to recoupe costs to be able to buy more phones. The amount I make on UA-cam at the moment is definitely not enough to cover those type of expenses lol. Once my channel grows and generates enough revenue to be able to go that further step, then ill be glad to do it :) honestly the revenue it generates for me right now puts me in a loss every month with the cost of buying the phones so its just a hobby at this point and not my full time work :)
Front camera you no need to use heat to pick out like Poco F3 ?
I came across this video as I'm trying to replace the charging port. Now it looks easy to me as long as I have the tools I need. Thank you!
👍
Where did you get the adhesive? I cant find it for that model anywhere can you please give me a link.
You would probably need one of these battery door cover replacement parts which come with the adhesive pre installed. They don't seem to be selling the pre cut adhesive by itself for this phone. www.aliexpress.com/item/1005003697199471.html?spm=a2g0o.productlist.0.0.7f4a92e34vAp1s&algo_pvid=2d23a939-b038-4bc3-a40b-1eed95e27932&algo_exp_id=2d23a939-b038-4bc3-a40b-1eed95e27932-0&pdp_ext_f=%7B%22sku_id%22%3A%2212000026842857920%22%7D&pdp_pi=-1%3B31.31%3B-1%3B-1%40salePrice%3BUSD%3Bsearch-mainSearch
Subscribed man. This is a good channel 👍
Thanks!
Can't wait for z fold/flip 3 teardown
👍
I was hoping you would show how the Popup trigger mechanism works... Still, an amazing video nonetheless, here's the like 👍
Thanks! Ya didn't think about doing it, should have.
Excellent You Teach Everything....
👍
Bro how much is glass back remove and apply i new one please tell me
Wait there is actually a physical proximity sensor in poco f3 GT, then why it fail the proximity sensor test.
Bc I did see other youtuber doing the proximity sensor test in mi x 5g & f3 gt and they said there isn't a physical proximity sensor. So what to believe now
Yes, it has a physical proximity sensor. It's also listed in the specs on the website.
@@PBKreviews then why it's not working properly 🤷
Maybe it's a really crappy one
I read somewhere that it is not the regular proximity sensor instead they used ultrasonic proximity sensor which is kinda new. Maybe it will get better after a few updates
I like that you almost cover new lounchwd phones
👍
Nice work brother
Thanks!
hello, will the f3gt come to turkey?
Is it a glass back? I have redmi k40 gaming and im just wondering if its a glass back. When holding its like a plastic to me.i n my opinion
Its a type of glass, has some flex to it but very little to make it more rugged and not shatter as easily or break. Not plastic.
@@PBKreviews thank you
I have a question sir. Do we have to remove the logic first whenever we do port replacement on this phone? I've seen a video where he does it. I asked but got no response. Hoping you can clarify this to me as I am trying to do it myself. Thank you.
No just the sub board/charger port board on bottom
Thank you sir! Now I'm ready to do it just waiting for the port replacement to arrive of my K40 Gaming Edition. @@PBKreviews
How much heat is needed to weaken the adhesive on the back cover? Will using a heat gun damage the internals? Thanks.
Great video
Hi, you can always use a hair dryer if you are not sure since there is less of a risk of damaging anything. But you need to evenly heat up the back cover to the touch so when you touch it, its hot enough make it uncomfortable to leave your finger on it. You can always apply more heat as your working your way around prying it off. Also if you need to gain leverage to get your pry tool in between the back cover and frame, you can use a suction cup tool to help you lift up.
@@PBKreviews thanks a lot, will give it a go
Thank you greetings from Turkey 👍
Hello, you're welcome and thanks! :)
Does it come with a preinstalled screen protector just like the k40/poco f3?
Yes
Where is the second speaker from the top
It's the aluminum part on top with the white and blue stickers.
The top speaker of my k40g got crackles. Few first time i just knock it out or reset the phone then it work fine again. Now it crackles full time. Do you think replace speaker will help?
It's possible. Might be debris that got attracted from the speakers magnet to the speaker causing it to do that. You might be able to clean it off from the speaker filter once you remove the speaker.
@@PBKreviews thank you so much
Bro is there any way to replace the volume rokerrz mine is damaged
Yeah, I'm not sure if they are push in or pull out ones. If its pull out ones, they should be able to be pulled out. If not, you need to take the phone apart and remove the rubber gasket in the frame, pull out the flex cable for the volume keys from the frame slot and push in the physical buttons into the frame to remove them.
how to change Rear Housing Glass Battery Back Cover by my self?
Thank you sir
You're welcome
im thinking of buying this phone, but the battery replacement seems too deep. What do you think?
Its not too difficult to replace the battery.
Removing the blue wire will definitely not recognize the USB when plugged into the computer
My Phone MI POCO F3 working well Only During WHATSAPP VOICE MESSAGE and Recording, but not working in Normal Calls. i change the MIC sub board and strip also but dost not work.
How to solve??
Is it true that it is liquid cooled?
By liquid cooled, they refer to the copper heat pipes or copper vapor chambers since they have liquid vapors inside.
what is the Cost of vibration moter of f3 gt...
My poco f3 gt's vibration not working..
I'm not sure what the price is on it, each website might have different price.
Brother i need a scrap motherboard of poco f3gt can you please help
Thanks
Welcome
I need to repair my poco f3gt display folder plz reply I'm from India assam
Nice
👍
❤
👍😀
Good
👍
nice🎉
👍
Gracias
You're welcome
is it waterproof ?
It's IP53 rated for water resistance. No phone is water proof, they are just water resistant. Enough water or pressure will cause the phone to get damaged.
Is poco F3 gt lcd compatible on Poco f3? Both are same 6.67
Should be, if I'm not mistaken.
@@PBKreviews can you test it sir?
Bro my device is poco f3 gt. My back panel and camera lens is cracked so would you help me to buy it can you give me the link to buy them plzz i have searched it for many shops 🥴
Here is a link: www.aliexpress.com/item/1005003249224927.html and on the same site, you can search poco f3 gt camera lens and you will see the camera lens part.
Poco f3 gt ic shart circuit breaker i need help bro
Problem
no idea about it.
I wonder if you could use a redmi note 10 pro screen on a Poco X3/Pro. It would be a pretty cool mod
Hi, it wouldn't work since the screen cable is different and located at a different location on the phone.
@@PBKreviews F, guess no Poco X3 with amoled for me xd
mere f3 gt ka motherboard dead hogya he.
kya aap aapke f3 gt ka mujhe motherboard de skte ho plzzzzz
I don't have the phone anymore, they are sold off after the videos.
@@PBKreviews bro motherboard mila kya sc centre wale to charge mang rhe he 15000
bro motherboard mila kya sc centre wale to charge mang rhe he 15000
Bro i need help
With what?
@@PBKreviews i want back door on poco f3 gt
Redmi k50 i please
It would be the same as the Poco X4 GT teardown video we did. Just rebranded.
@@PBKreviews ok
Very good video bro, meanwhile it would be awesome if you could take out the entire vapour chamber/cooling part by removing the screen, yes I'm well aware about the fact this will destroy the device. I'm searching for Jerryrigeverything2
Thanks. Ya at the moment if i were to destory the phones, i wouldn't be able to continue doing videos for very long since I would not be able to recoupe costs to be able to buy more phones. The amount I make on UA-cam at the moment is definitely not enough to cover those type of expenses lol. Once my channel grows and generates enough revenue to be able to go that further step, then ill be glad to do it :) honestly the revenue it generates for me right now puts me in a loss every month with the cost of buying the phones so its just a hobby at this point and not my full time work :)
@@PBKreviews no worries man you already doing great job