tip from a RC heli guy you can put some hot glue on your ESC and servo connectors itll keep them from backing out and you can easily remove it you can also use it hold some of the smaller wires in place as well
Hi, yeah, at the moment I have receiver in T-FHSS -HS (high speed mode). In the manual it says to only use this mode only if you have a "Futaba digital servo". But i've had no problem using this mode with the Savox servo so far.
tip from a RC heli guy you can put some hot glue on your ESC and servo connectors itll keep them from backing out and you can easily remove it you can also use it hold some of the smaller wires in place as well
ohh really! I've never seen that. Guess it acts to seal it from water too. Thanks, I'll take a look at that 👌
yeah we use it since helis vibrate a ton just put bunch of hotglue around the connectors on the RX and itll keep them from back out :D
Yeah I can imagine that could be fatal on a heli 😳
Be careful if the heat with your esc so close to the motor
Are u using the TFHS settings on the receiver
Hi, yeah, at the moment I have receiver in T-FHSS -HS (high speed mode). In the manual it says to only use this mode only if you have a "Futaba digital servo". But i've had no problem using this mode with the Savox servo so far.