Oh man, that sucks! I’m not sure if this is Rob. I would check your cooling first. Maybe increase the pick up inlets on your rudder and tubing size. I drilled out my rudder, pick ups, nipples on the motor and increase my tubing ID and I’ve seen a significant decrease in temps
A now i get it (2200kv on 8s). I assume you "loose some speed" because off small prop and hi kv and blow the motor because off rpm. I can tell what i have to give maybe guideline. My thoughts; i ran 89+ with 1650kv 4092 and 45-3blade no crazy temps and able to play around with it a full pack with some full pulls. Since your trying to set a 100, i would try a 1800kv, also would install a fan on motor since your running single runs so has extra cooling for the extra heat generated by higher kv. Dont know the oxi props, but they look to be very good 2 blades, so get a couple off sizes. One extra mm prop is about 1-2mph.. 1 inch shortened rudderblade is about 3-4 mph. On my boat also strut near neutral was best, also tried bit up and lipo's more forward but gained few mph by lowering it and putting lipo's bit more back. Thats what i can tell and measured and experienced so far on my dom. Btw got a 1800 in it now, but don't run anymore this season because its getting cold and don't have rescue boat... Maybe this helps, maybe some one else has better tips. I also truly believe 100+ is possible and think Raider might be a better hull also to do so.
@@gen1power102 I also run sss btw... Not saying tp isn't any good, but cheaper and good for sure. Pushing it maybe bit less, but never had an issue with it. And with same setup blew a castle 1520 in 3 runs, so an expensive motor doesn't mean its better if you ask me...
Oh man, that sucks! I’m not sure if this is Rob. I would check your cooling first. Maybe increase the pick up inlets on your rudder and tubing size. I drilled out my rudder, pick ups, nipples on the motor and increase my tubing ID and I’ve seen a significant decrease in temps
Heck yeah thanks Bro 🤟🤟🤟
In all honesty it was a 6S motor and I was running it on 8S.
@@Wildwilliesrc well there you have it
A now i get it (2200kv on 8s). I assume you "loose some speed" because off small prop and hi kv and blow the motor because off rpm.
I can tell what i have to give maybe guideline. My thoughts; i ran 89+ with 1650kv 4092 and 45-3blade no crazy temps and able to play around with it a full pack with some full pulls. Since your trying to set a 100, i would try a 1800kv, also would install a fan on motor since your running single runs so has extra cooling for the extra heat generated by higher kv. Dont know the oxi props, but they look to be very good 2 blades, so get a couple off sizes.
One extra mm prop is about 1-2mph.. 1 inch shortened rudderblade is about 3-4 mph. On my boat also strut near neutral was best, also tried bit up and lipo's more forward but gained few mph by lowering it and putting lipo's bit more back. Thats what i can tell and measured and experienced so far on my dom. Btw got a 1800 in it now, but don't run anymore this season because its getting cold and don't have rescue boat...
Maybe this helps, maybe some one else has better tips. I also truly believe 100+ is possible and think Raider might be a better hull also to do so.
Thanks for all the advice. Yes I think so too. It’s a very stable hull. Thanks again Brother 🤟
Great advice.
You asked for suggestions. Here's mine. Go with R/C aircraft.
Why???
That stinks man, surprised a TP got that hot. I've had good luck with leopard motors
258 degrees
Well!? This explains a lot!
Is your motor water cooled ? Id get a water cooling set up and run a leopard motor
Yes sir it’s water cooled. Not a big enough cooling jacket though.
I run sss brother… they’re top notch and if GEN 1 can’t blow it it’s truly unbreakable! 💪🏽
I already ordered a TP but a lower kv. I’m going to try SSS next for sure. Thanks for watching and I watch all your vids 🤟🤟🤟
@@gen1power102 I also run sss btw... Not saying tp isn't any good, but cheaper and good for sure. Pushing it maybe bit less, but never had an issue with it. And with same setup blew a castle 1520 in 3 runs, so an expensive motor doesn't mean its better if you ask me...
90 mph scale maybe, but certainly not real 90 mph. Probably 40 or 50 legit.
Okay Bro 😂
Is there such a thing as scale speed vs real speed?! If the GNSS has an object moving at X speed isn’t that real ?