Laser Engraved Tie Clip Tutorial Beginner Friendly

#xtools1 #xtool #laserengraving #tutorial
In this video I show you how to laser engrave a tie clip.
Interested in supporting my channel?
www.buymeacoff...
Below are some products I have talked about on my channel.
Tie Clips amzn.to/3WD6mJv
Bamboo Pens amzn.to/3wvET1N
Jewelry Cases amzn.to/4bxN7oX
Flask amzn.to/3JUVDTp
Compact Mirror amzn.to/3UAUUvq
Slate Stone Coasters amzn.to/3WfHxDi
Cast Acrylic Sheet,Colored Acrylic Sheet amzn.to/4afMtw3
Basswood Sheets 1/8 x 12 x 12 Inch amzn.to/4al211W
xTool RA2 Pro for xTool amzn.to/3xou2qp
xTool S1 Laser Engraver, 20w amzn.to/3PHeZi4
Wallet Bottle Openers amzn.to/3U4YYFk
As an Amazon Associate, I earn from qualifying purchases if use my links. Thank you for supporting my channel.

[@allanbourner4569]

Could you not use a chunk of Blutack to hold it in the required position?

[@liciatoday]

Not sure what that is. However, you can pretty much make a jig for anything. Some people don’t have the time or resources to keep getting or making different accessories so I show that you can use what you already have. Thanks for watching 😀

[@ronr179]

You been pretty active with your 20w. Where do you find your settings?

[@liciatoday]

I either use the presets adjusted if needed or do a materials test array.

[@ronr179]

@@liciatoday becomes pricey if you have different brands/styles of tumblers

[@liciatoday]

@@ronr179 I have been lucky so far with the settings plus I have tumblers I already messed up from other reasons I use as my test. I do sell various types of tumblers so I buy in bulk so it’s not too expensive. I just purchased some 40oz with the handles so waiting on those to come in so I will figure out how to do those too.