Nissan Urvan Estate ZD30 E25 rough idle and white smoke loss compression

Поділитися
Вставка
  • Опубліковано 27 гру 2024

КОМЕНТАРІ • 22

  • @cookieguyyt856
    @cookieguyyt856 2 дні тому

    gnyan din tunog ng urvan na minamaneho ko ngayon.hard start tapos nag vivibrate ang engine twing reverse at 1st gear.tapos may umuusok na.mgkano magagastos boss?

  • @jessieworkz6107
    @jessieworkz6107 28 днів тому +1

    What cause of knocking sound

  • @HarrisAgima
    @HarrisAgima Рік тому +2

    Very impressive, u reuse the block do you?

    • @imeedesu1595
      @imeedesu1595  Рік тому +1

      I'm using a Japan surplus engine which is in good condition

    • @arthururamani9481
      @arthururamani9481 Рік тому +1

      Yes

    • @HarrisAgima
      @HarrisAgima Рік тому +1

      @arthururamani9481 please may help giving the correct torque spec for cylinder head bolts, con rod bearing and main bearing bolts for Nissan urvan Zd30 E25 please

    • @arthururamani9481
      @arthururamani9481 Рік тому

      @@HarrisAgima yes please please please

  • @zen6643
    @zen6643 Рік тому +1

    sir how much limit for cylinder head skimming?

    • @imeedesu1595
      @imeedesu1595  Рік тому

      There's a markings on the cylinder part for the maximum resurfacing.it should not reach that parts or otherwise your compression ratio will suffer causing misfire

    • @zen6643
      @zen6643 Рік тому

      @@imeedesu1595 may i ask how much torque for cylinder head bolt sir?

    • @zen6643
      @zen6643 Рік тому

      @@imeedesu1595 and any tips for timing cover gasket to prevent it from leaking water after installed

  • @arthururamani9481
    @arthururamani9481 Рік тому +2

    How to get white smoke out

    • @imeedesu1595
      @imeedesu1595  Рік тому +2

      I depends on the situation of white smoke is,if only when cold start it appears and after a few minutes it's gone, valve seals or injectors o-rings, but when it's all the time, maybe your turbo charger, but when engine is running with check engine lights on and knocking sounds, possible it's from your injection pump

    • @kilavavine2240
      @kilavavine2240 2 місяці тому

      Good😅😅

  • @atanaciobalucan3123
    @atanaciobalucan3123 6 місяців тому

    Sir magkano lahat gastos pag general overhoul sur parts machineshop ska labor

    • @imeedesu1595
      @imeedesu1595  6 місяців тому

      09108359396

    • @RomelNaing
      @RomelNaing 3 місяці тому

      ​@@imeedesu1595 bossing mgknu magagastos pag sa my blue by

  • @mariogamilo8021
    @mariogamilo8021 Рік тому

    Location nio po sir