MINI EXCAVATOR TIPS

[@vdubluv222]

great video. thank you! i was due to buy something else from Milwaukee LOL.

[@LB-sk3vl]

Is the hydraulic filter inside the tank ???

[@DAS-Videos]

I would add that people may want to disconnect the two hoses for the swing bearing and then pump grease into the fittings until grease comes out of the disconnected hoses. I thought I was greasing mine thinking the hoses were already full but nope. I had to pump quite a lot of grease until it came out of the hoses.

[@normhowes2975]

Great points on changing zerk fittings out. That was the 2nd thing I did as the 1st was 'attempting to grease mine. OK that was after I made a small hole in the ground lol

[@aguyandhismuttgarage]

I also made the rear panel into a door with some weld on Barrel hinges. It's much easier to gain access now.

[@DrSweetshaft]

Grease every time? Sounds excessive.

[@JLonz-hz8hi]

What Amsoil Hydraulic oil did you use? Did you notice a difference in the operation of the Machine? IE smoother controls.

[@aguyandhismuttgarage]

I used iso 46 and it operates the same it was smooth before the fluid change anyway.

[@jayjames1657]

I have the same one you have
This is the first video I have seen foe a miva va15 mini
Right now i have a problem if where my hydraulic is not working it wont walk the boom and bucket moves very slow

[@PovertyPointCustoms]

They are about 2100lbs, most assume they are 1.5 tons or 3000lbs

[@dirtydish6642]

Daaang! What does a unit like this cost these days?

[@kennethkirkham2471]

Just paid $5800 with a hydraulic thumb.

[@jgrohio]

Grease fitting metric?

[@cherylhagen4425]

Yes metric

[@alexanderthevoice]

Idlers and rollers doesn't have grease port, they are sealed with oil. Actually they use engine oil in my ViO-55. Same as the final drives.

[@DrSweetshaft]

I was wondering how to lube those, thanks

[@jayjames1657]

Mine did come with Briggs and Stratton engine