VE/VF commodore Suspension & 6pot Brake upgrade Pt2 update hit a couple of PROBLEMS!

Well a few weeks ago I uploaded the first part of the suspension and brake upgrade. In that video I was still waiting on the Braided lines - Because of #Covid-19 they were delayed. They finally arrived so I could get everything fitted. The Pedders XA coilovers went on easy and I have it on the lowest setting. Compression is right now in the middle but a bit soft for me. The front sway bar was difficult if you do the swap, you need to remove the engine mounts and lift the motor 100mm to get it past the electronic steering rack in a VF at least, might not be an issue with VE commodore. The endlinks from factory were past their used by date. The biggest problem was the Circo pads on the front- when seated in the caliper the overall diameter is 2mm smaller than the thickness of the disc, so it required me to skim some off the top layer otherwise the pad would get the rotor hot and both glaze the rotor and pad ruining any upgrade in performance. So yet again this is just a tie over until I get time to finish the rest of the job off next week.

[@5150mkii]

How about a video of the finished product?

[@nazirtrabulsieh4651]

Good job mate looks awesome

[@johnangel052000]

I have mine set on 15 clicks what’s the best setting